EJERCICIOS RESUELTOS DE MODELO DE TRANSPORTEDescripción completa
problemas de trasnporte IODescripción completa
tres ejercicios de transporte de fluidosDescripción completa
Full description
Descripción completa
Descripción completa
solucion con solverDescripción completa
31 ejercicios de modelo de transporte planteados y resueltos del área de investigación de operacionesDescripción completa
31 ejercicios de modelo de transporte planteados y resueltos del área de investigación de operacionesDescripción completa
31 ejercicios de modelo de transporte planteados y resueltos del área de investigación de operacionesFull description
31 ejercicios de modelo de transporte planteados y resueltos del área de investigación de operacionesDescripción completa
Ejercicios de logística en transporteDescripción completa
Descripción completa
Descripción completa
Descripción: IOM
Descripción: poli
Descripción: sdadsdasd
Descripción completa
Descripción: Ejercicios relación peso - volumen.
EJERCICIOS PARAFENÓMENOS DE TRANSPORTE TEMA 1
RESPUESTAS
Molar concentración of CO at catalytic surface
Diffusion Limited
TEMA 2
Respuestas
TEMA 3
An experiment is designed to measure the partition coefficient, K, associated with the transfer of a pharmaceutical product through a polymer material. The partition coefficient is defined as the ratio of the densities of the species of interest (the pharmaceutical) on either side of an interface. In the experiment, liquid pharmaceutical ( p = 1250 kg/m3) is injected into a hollow polymer sphere of inner and outer diameters Di =5 mm and Do =5.1 mm, respectively. The sphere is exposed to convective conditions for which the density of the pharmaceutical at the outer surface is zero. After one week, the sphere’s mass is reduced by M = 8.2 mg. What is the value of the partition coefficient if the mass diffusivity is DAB =0.2x 10 11 m2/s? -
Respuesta
TEMA 4
Hydrogen at a pressure of 2 atm flows within a tube of diameter 40 mm and wall thickness 0.5 mm. The outer surface is exposed to a gas stream for which the hydrogen partial pressure is 0.1 atm. The mass diffusivity and solubility of hydrogen in the tube material are 1.8 x10 11 m2/s and 160 kmol/m 3 atm, respectively. When the system is at 500 K, what is the rate of hydrogen transfer through the tube per unit length (kg/s .m)? -
Respuesta
TEMA 5
Respuesta TEMA 6
Respuesta
TEMA 7
Estimate values of the mass diffusivity DAB for binary mixtures of the following gases at 350 K and 1 atm: ammonia – air and hydrogen – air.