Method Statement for Installation of TransformerFull description
Method Statement for Installation of TransformerFull description
okayFull description
cathode protection Method statement for installtion
bacaanFull description
This document describes the installation method for GRP tanks installations. especially needed by the consultants and to be provided by contractors.
bacaan
This document describes the installation method for GRP tanks installations. especially needed by the consultants and to be provided by contractors.Full description
This document describes the installation method for GRP tanks installations. especially needed by the consultants and to be provided by contractors.
okay
Thanks.
dfgdfg
Method of Statement for Duct Installation
Method Statement for Installation Safety Crash Barriers is Civil Engineering documentation useful reference for your project. The document specify the various methods of installation.Full description
iguyDescription complète
Description complète
Method StatementFull description
Method of Statement for Duct Installation
HVAC Duct Work Installation Method Statement
fire alarm systemDescription complète
MS PPR piping installation
dfgff
jygjhDescription complète
Method Statement for Installation of Transformer Purpose
The purpose of this method of statement is to explain step by step method to implement the correct practices for t he installation of transformer through the guidelines contained herein so as to ensure that the job execution complies with the project requirements and serves the intended function to satisfactory level. Required Instruments & Tools
Fork Lift or Crane, pallet mover with capacity & arrangement in line with the Manufacturer’s recommendations and as required at site. Portable hand tools. Portable Drilling Machine/ Grinding Machine & Angle Cutter. Spirit Level/Level Threads. Digital multimeter. Earth resistance tester. General Installation Requirement
1. Ensure all civil works are completed for t he area including floor paint to carry o ut the installation, and clearance is obtained from respective authorities to proceed further. 2. Prior to start the installation, refer to the approved shop drawings related to the area of installation and ensure that required materials are available at site as per approved material submittals. 3. Ensure the materials are stored properly and there is no mark of damage or deformity of any kind before issuing the material from site store. 4. Transformer will be off loaded to the place nearest to the installation and protected properly from dust & environment, etc. 5. Prior to installation, the foundation will be checked for cleanliness and level. 6. The unit will be inspected prior to shifting to site for any mechanical and structural damage during transportation. 7. The name plate will be checked ag ainst equipment data sheet to confirm conformity with the approval. 8. Ensure the installation of Transformers are carried out in ac cordance with manufacturer’s and local authority’s installation recommendations, requirement of applicable standards and in accordance with recognized industrial practices and specified in project specification to ensure that installation complies with requirements.
Installation Procedure For Transformers
1. Where auxiliaries are shipped loose, these will be identified and checked against the dispatch documents. Any item found missing or damaged will be noted to the supplier immediately for the replacement / repair. 2.
Special attention shall be paid to the condition of instruments and monitoring devices supplied loose or installed along with the transformer.
3. Transformer will be moved by crane using lif ting lugs as per manufacturer’s, recommendation and shall be positioned on Transformer base in plant yard. Transformer will be moved over rails and brought to the position as indicated in the drawing, after installation of wheels at base. 4. The installation will be checked by site electrical supervisor and engineer for proper placement and orientation of Transformer. 5. After final positioning of transformer, all wheels will be locked to ar rest any movements of the transformer. 6. Transformer auxiliaries and instruments will be installed as per manufacturer’s recommendation / guidance with close supervision of site Electrical supervisor and Engineer. 7. HV and LV side termination shall be carr ied out as per approved drawings. 8. Transformer Earthing shall be done as per loc al authority Regulation, specification and approved drawings. 9. Conduct risk assessment. 10. After inspection of Transformer and approval by local authority and Consultants, proper care will be taken to protect the unit from dust by suitable covering, and shall further be released for the Testing work.
