Availables Command in CPP RBS via MoshellDescrição completa
MOSHELL Commands v14Descrição completa
moshell tutorialDescrição completa
3G COMMANDS WITH COMMAND moshell It all lst node b name st utrancell st utrancell ENA st utrancell DIS altk/alt lst m3ua lst sccp lst mtp lgaeus strt node b name st ranap uer ala lh ru fui get vswr cabx lst all get radio lh ru fm getfault lst sector=antenna1 st rru-1 st sitename get siteID scrambling lga st plug
THEIR USE USE to login the particular RNC / Node B to load the RNC/node B to see the status of particular node to see the all sites to see the status of upsites to see the status of downsites to see the alarms of whole RNC these commands are used when association (means RNC isolated or fibre cut or SGSN down) is down to see the status of down sites for particular time period it will give the inform ation of particular node with every sector to see the link of node b (link is going from which node b) not clarified To view detailed alarms (NodeB/RNC) To check vswr level for a site; should be above 14 To check temperature and card detail for nodeB To view all proxy IDs for a nodeB To view traffic to view proxy IDs for a particular sector to check proxy IDs for the entered node B to check the proxy at te RNC to check the scrambling code of the site only at RNC to view the history of the alarms to view the proxy of the hardware rack
example moshell or moshell or moshell
lgaeus 2h--- here 2h means 2 hours ,it will show the down sites of last 2 hours for each sector , if values are 111111 means sector is up and if it shows 00000 for particular sector then sector is
