Cisco Academy documented lab for creating a Peer to Peer NetworkFull description
Peer to Peer
jaringan komputer
jaringan komputerDeskripsi lengkap
jaringan komputerFull description
Peer to peer data transfer received a lot of attention in recent years. A peer to peer network allows users to communicate or send data over a network without any server. A peer is any computer client or user. So that it called Peer to peer P2P netwo
Education
Peer AssessmentFull description
thesis
Full description
Peer AssessmentDeskripsi lengkap
LABORATORIO DE CCNA1 10.1.2.5Descripción completa
Full description
Descrição completa
contoh Media Pembelajaran Peer TeachingFull description
OBJECTIVES In this activity, trainees will perform the ff: 1) Prepare network cables 2) Configure network adapter for LAN settings 3) View and test network connection using ipconfig and ping command. TOOLS, EQUIPMENT, MATERIALS 1) TOOLS – Crimping Tool, wire stripper, LAN cable tester 2) EQUIPMENT – Desktop Computers, router, patch panel 3) TASKS 1. 2. 3. 4. 5. 6.
Connect the network cable to PC-1 and then PC-2 on the other end. Open Control Panel. Click Start > Control Panel. Click “View Network Status and Task” under Network and Internet Category. Click “Change adapter settings” on the left pane of the window. Right click “Local Area Connection” and select “Properties” . In the Network Tab, locate and select “Internet Protocol Version (TCP/IPv4)” then click the button “Properties“. 7. In the properties window, select or tick the button “Use the following IP address:”. 8. Enter the following details: a. IP Address: 192.168.100.1 b. Subnet Mask: 255.255.255.0 c. Default Gateway : (N/A) d. Preferred DNS Server : (N/A) 9. Click OK and close everything. 10. Check your network configuration. Click Start > Run. (You can simply open “Run” utility by pressing “Win Key + R” at the same time in the keyboard). 11. Type “cmd” and hit “Enter” key. 12. Once cmd is ready, type ipconfig and hit enter. You should see the results. 13. Look under “Ethernet adapter Local Area Connection:” , you should see the IP address and subnet mask you entered in Step 8. If you get a different result, check your network details as stated in Step 8. 14. Perform the above steps to PC-2. Make sure that you will not use the same host id in PC-1. 15. Check network connection using ping command.
Check Network Connection: 1. 2. 3. 4.
Click Start > Run. Type cmd and hit Enter. In the cmd window, type ping and hit Enter. If there is a reply coming from the partner computer, then you have a successful connection. 5. Perform the same thing on the partner computer.
