Overall length 6", .625 diameter A. .045 deep,.285 deep,.285 dia. This can be cut deeper, then faced ! t get the depth right. . #rves are .$25 %ide &. Tab left is .$25 %ide '. (le .)*5 dia, 5" deep +. ull dia fr ).$25" . .500 dia 2.8*5 lng #. .)*5 slt 2" lng, starting $" frm end (. .$40 %ide, .425 lng, lng, starting ).425 frm end - started b cutting the headspace n the head f the blt, starting %ith an end mill in the tail stc/, then a small bring bar bar t enlarge it. - culd have cut the grve fr the etractr spring then, but - didn1t. Then turned it arund arund and turned the bac/ bac/ end t .500 and drilled the.)*5
hle. - then threaded the hle at 40 T-. After the bd is plished it cmes ut f the lathe and ges in the mill. The 3rst cut is %ith a )8 end mill .$25 deep, starting at the head end, abut 2.5" lng. Then - cut deeper t pen up the bd frm $" frm head fr 2" lng. 7te # &hange t a $8 end mill and cut grves "" .$25 %ide and deep. - used the $8 end mill t cut the slt "(" .$40 %ide, .425 lng, at ).425 frm head. +tractr grve and etractr spring grve can be cut n% r after the etractr is made s psitin can be ad9usted if necessar.
:tri/er is .)50 diameter. &c/ing piece is a piece f the blt bd material bred and reamed t .50$".- thin/ everthing else is clear. - didn1t cut the .$40 slt in the blt bd until after - had made the cc/ing piece s the ramp %uld 3t right. All pieces re;uired "3tting" t ma/e it perate. The 3ring pin is a piece f $$6 stainless %elding rd. After the stri/er and blt bd %ere made - put the stri/er inside the bd and drilled d%n frm the rim area n the blt face thrugh the bd and int the stri/er. This ensured the hles %uld line up. Then the pin %as lctited int the stri/er and cut and shaped t length. The little plug scre%s int the bac/ f the bd t retain the spring. :pring
tensin can als be ad9usted sme%hat b the plug.
arrel lug %as a piece cut %ith a $.050 diameter t 3t arund the receiver and .20 t 3t arund the barrel. Then shaped and tapped fr the
brac/et.
