vehicle inspection sheet to be safe and keep maint low.Full description
ST Exchanger Inspection ChecklistFull description
checklistDescription complète
Formwork Inspection Checklist
CHECK LIST FOR INSTALLATION OF EARTHING SYSTEM Contractor
For
:
Rev Sub-Contractor
Page:
:
SECTION OF WORK:
LOCATION:
LEVEL: C!ec"e# b$ Stage
C!ec"e#
Ite
Check against approved electrical shop drawings. %re-&n'ta((at&on
Check if the sleeve level and thickness of the pipes are as per approved shop drawings. Seal all sleeves as per specification. Check if sizes of the earthing wires are as per the approved shop drawing. Check cable trays, trnking, and e!ipment "!ipotentially bonded bonded as per pro#ect specification. Check if locations and sizes of earth bar are as specification and approved shop drawings.
Eart!&ng S$'te In'ta((at&on
Check if that earthing wire$s% is connected to e!ipment as per shop drawing in proper way. Check the level & location of earth pit as per approved shop drawings. Check if earth pit fi'ing is as specification and approved shop drawings. Check the connection$s% of earthing wire to earthing rod electrode.
Te't&ng
Check if earthing resistance reading is less than ( )hm and sbmit earth resistance report. Check "arth Continity test for all metal parts and e!ipment of of bilding.