GENEX Probe V300R014Voice Quality Evaluation (MOS) Test Guide
Guide to Perform Initial DT With GENEX Probe
curs
Full description
DDR / Katalog
MACKINTOSH PROBE – METHOD STATEMENT
DDR / Katalog
This paper presents and discusses several experiments and research carried out in the Central Area of Brazil, in which dynamic light cone penetrometers (DPL´s) have started to be tested into…Descrição completa
huaweiFull description
node BFull description
Geotechnical Engineering Laboratory
Full description
report
Huawei Genex Probe User Guide
Connecting UE to laptop
Plug UE to USB port -> Drivers will attempt to install automatically (if not successful); Go to Computer -> Select UE drive -> run ‘hwpcassistant’ -> install driver software
UE should be able to connect after driver installed. to confirm; Go to device manager -> view Ports (COM & LPT) -> once the UE connects successfully the Laptop will assign a COM port
Starting Probe
Prior to starting Probe software, Huawei Engineer will provide installation software/license. Open
The software will prompt you to update license; follow instruction and update accordingly
After license update successfully, the Probe software will now be usable.
Starting Probe
After license update successfully, the Probe software will now be usable.
Saving a Project
Creating a New Project
Project -> New -> Select template type based on Network
Project -> New -> Select template type based on Network
Configuring Test Devices
Device configuration window will be displayed:
Adding UE to Probe: Select MS -> Select add device the device configuration dialog box will appear.
Confirm COM port -> Select UE Model -> Modem Port will be assigned automatically -> Select OK.
After successfully added UE the below highlighted RED RED can can be observed.
Configuring Test Devices
Device configuration window will be displayed:
Adding GPS to Probe: Select GPS -> Select add device the device configuration dialog box will appear.
Confirm COM port -> Select GPS Model (NMEA NMEA)-> )-> Modem Port will be assigned automatically -> Select OK.
Configuring Test Devices
Connect Devices
Connect Devices
Configuring Test Plan
Test Plan will be created by Huawei Engineer (Configuration -> Test Test Plan Control -> The TEST Plan Control dialog window will appear.
Each UE can be configured with a defined function controlled by Test Test Plan. These Test Test Plan will be provided by Huawei and upload to UE according to drive test requirement. UE 1 – Short Call UE2 – Long Call UE3 – Data UE4 – Idle (No test plan required)
Configuring Test Plan
Probe software can be controlled from the main window to the left of screen.
Configuring OutdoorMap
Select folder highlighted RED -> Navigate to Map director -> select map (.tab file) -> Open