Soal 1. [SingleChoise] Which of the following statements is correct of RAI? A. MCC+MNC+LAC+RAC
B. MCC+MNC+LAI
C. MCC+MNC+RAC
D. MCC+MNV+LAC
2. [Singlechoise] Which method of LAC definition is correct? A. One BSC with one LAC
B. Two BSC under the same MSC with the same LAC.
C. One BSC with two LACs
D. Two BSCs belong to different MSC, with the same LAC.
3. [Singlechoise] Second Carrier and Third carrier are the expansion of? A. 3G site
B. 2G site
C. GPRS packet data
D. EDGE packet service
4. [Singlechoise] What are kind of Handover A. Softer Handover
B. Hard Handover
C. Soft Handover
D. Soft Handover and Hard Handover
5. [Singlechoise] What is RSCP?
A. Received Signal Code Power
B. Radio Signal Code Power
C. Resources Scrambling Code Power
D. Received Scrambling Code Power
6. [Singlechoise] On 3G System. The Situation belong to Hard Handover is? A. Hand over from 3G to 3G in same Frequency
B. Hand over from 3G to 3G in different Frequency on the same RNC
C. Hand over from 3G to 3G in same frequency with diiferent LAC
D. Hand over from 3G to 3G in same frequency with different RA
7. [Singlechoise] Video Phone/ Video Call is belongs to which service? A. PS service
B. Interactive service
C. CS service
D. Background Service
8. [Singlechoise] What kind of antenna which used for coverage purpose? A. Sectoral antenna
B. Microwave antenna
C. Tower Mounted Amplifier
D. RRU
9. [Singlechoise] Location Area Update NOT happen when ... A. Cell Selection
B. Cell Re-selection between cell with different LAC
C. Cell Re-selection to other Cell in different RNC
D. Cell Re-selection to other cell in one RAC
10. [Singlechoise] Not the Causal Factor of Call drop in 3G system A. Alarm or Hardware problem
B. Bad RSCP
C. Inter System Handover
D. Bad Ec/No
11. [True/False] Sometimes we say Ec/Io and sometimes we say Ec/No, they are different A. True
B. False
12. [True/False] MS of B type can be attached to both GSM and GPRS network at the same time. A. True
B. False
13. [True/False] Same BCCH-BSIC combination in adjacency will lead Hand Over Failure A. True
B. False
14. [True/False] Interference is the one factors to lead Call drop, but not effect to HOSR A. True
B. False
15. [True/False] In data rate of EDGE, maximum number of MCS is MCS-8 A. True
B. False
16. [True/False] BSIC (Base Station Identification Color Code) is consist of MCC and MNC A. True
B. False
17. [True/False] Intracell handover is an handover between cells in the same BTS A. True
B. False
18. [True/False] the unique feature in TEMS for analyze speech quality in 2G system is "FER" A. True
B. False
19.
[True/False] IRAT handover is Soft Handover between 3G to 2G system A. True
B. False
20. [True/False] Like RxQual in 2G, Ec/No in 3G only appear on Dedicated Mode A. True
B. False
21. [True/False] Location Area Update happen on Idle Mode only A. True
B. False
22. [True/False] For Physical Optimization; Mechanical Tilt should be used on Inner City Area and Electrical Tilt should be used on Rural Area. A. True
B. False
23. [True/False] Soft handover: when a UE is connected to cells owned by different NodeB and Softer handover: when a UE is connected to cells owned by the same NodeB. A. True
B. False
24. [True or False] In WCDMA network, the interface between NodeB and RNC is called Iub, the interface between RNC and RNC is called Iur, the interface between RNC and CN is called Iu, the interference between UE and NodeB is called Uu. A. True
B. False
25. [True/False] The maximum value of VSWR in the antenna should be less than or equal to 1.5. A. True
B. False
26. [True/False] In WCDMA mobile communication system, the diffraction capability is worse and the penetration capability is better at frequency 2 GHz than that at 900 MHz. A. True
B. False
27. [True/False] The reasons for Hand Over is Signal Strength (RX LEVEL) only
A. True
B. False
28. [True/False] PDTCH is used for packet service in 3G system A. True
B. False
29. [True/False] No dominant cell coverage is not the reason of ping-pong handover A. True
B. False
30. [True/False] Both of CS and MCS are belongs to data rate of GPRS A. True
