( C ) Commands for NOKIA SIEMENS DSLAM To login into the NSN DSLAM, get connected to Operation Domain VPN & Telnet the the DSLAM Enter
Login id- root Password- vertex25 Give command : enable ( to enter in enable or # mode ) configure terminal ( terminal ( to enter in configuration mode )
1)
To see the status of card Give Command : show : show slot-overview slot-overview It shows the status of all equipped card in module. Each card contains 72 ports. H ere Control cards are equipped in slot no.5 and 6.
2)
To Check the Status of Fan Give Command : show status fan
17
3)
To Check the configuration of each card separately Give Command : show table table shelf
4)
To Check the Card temperature of all Equipped Cards Give Command : show status temperature
18
5)
To Check the Port Admin & Operation Operation Status & xTUC xTUC & xTUR Line Rates Give Command : show lre s1 s1 xdsl phys-table linerates (Here s1 indicates the slot no. 1, enter s3 for slot 3 )
6)
To find the Slot & Port no. no. from particular inner VLAN VLAN & to Check the MAC MAC Give Command : show mac vlan vlan 137 ( here 137 is inner VLAN no. no. )
7)
To Check the Attenuation & SNR Margin for particular UP port Give Command : show lre 1/10 1/10 xdsl band-table ( 1/10 is slot no. / port no. )
8)
To Reset the particular faulty card Enter into Enable Mode by using command > enable Enter into Configuration Mode by using command # configure terminal in configuration mode give command : DSLAM(config)# reset card 2 ( here 2 indicates the slot no. ) OR DSLAM(config # reset all ( to reset all equipped cards )
19
9)
To Reset the particular Port Enter into Enable Mode by using command > enable Enter into Configuration Mode by using command # configure terminal In configuration mode give command DSLAM(config)# DSLAM(config)# bridge DSLAM(config # DSLAM(config # port lre 2/5 disable ( here 2/5 is slot/port no. ) DSLAM(config # DSLAM(config # port lre 2/5 enable DSLAM(config # DSLAM(config # show lre s2 xdsl phys-table linerates (check the port’s admin status )
To Reset the series of Port DSLAM(config # DSLAM(config # port lre 2/1-15 disable ( here 2/1-15 is slot / series of port no.) DSLAM(config # DSLAM(config # port lre 2/1-15 enable
