Epoxy Floor Coating Methodology

HANJIN HEAVY INDUSTRIES & CONSTRUCTION CO., LTD.

METHOD STATEMENT FOR APPLICATION OF EPOXY FLOOR COATING


LAGUINDINGAN AIRPORT DEVELOPMENT PROJECT

Laguindingan, Misamis Oriental

TABLE OF CONTENTS

I.

TOOLS, MATERIALS AND MANPOWER

2

II. INSTALLATION PROCEDURE a. Preparation b. Application

2 2 2

III. SAFETY MEASURES

3

Laguindingan Airport Development Project

Hanjin Heavy Industries & Const. Co., Ltd.

Page |2


TOOLS, MATERIALS AND MANPOWER

I.

Tools and Materials -

Electric grinder/ sander (Surface Preparation)

-

Stirrer (Manual or Electrical)

-

Adhesive Tapes

-

Blocking Strips

-

Paint Roller/ Brush

-

Vacuum Cleaner

-

Epoxy floor coating Material (A & B)

-

Epoxy floor coating Primer

-

Lacquer thinner (for cleaning)



Page |3


-

Vacuum Cleaner

Manpower -

1 Site Engineer/ Architect

-

1 Foreman

-

1 Skilled Labor

-

1 Labor Assistants

II.

INSTALLATION PROCEDURE a. Preparation

1.)

Surfaces to be painted must be thoroughly cleaned and free of oil, dust, and grease, and wax, old loosely adhering finish, cracking and scaling paint by wiping, scraping, and / or by sanding.

2.)

Ensure removal of grease and oil by use of solvent.

3.)

Surface must be thoroughly dry prior to primer application. b. Application

1.)

In a separate clean container, gently pour

down first all content of

the Sphero Part A, and then slowly add the content of Sphero Part B while at the same time stirring-up as they are being mixed. 2.)

Ensure that both Sphero A & B are separately stirred-up first for 1- 2 minutes before being mixed together to produce a homogeneous mixture.

3.)

Care must be considered in applying the mixed Part A & B because they could only be applied within 15-20 minutes as the mixture will be having a pot-life when both are already mixed together.

4.)

With brush, roller, or spray, apply 1 or 2 coats of SPHERO EPOXY FC SEALER.



Page |4


As topcoat, apply 2 coats of SPHERO EPOXY FLOOR COATING. Recoat

5.)

after 4-6 hours. Hard Dry in 24 hours. Full cure in 7 days.

6.)

III. SAFETY MEASURES Although most paints are generally safe to work with, you should take extra precaution to ensure there are no unnecessary accidents. Here are some general safety tips to follow when painting. 1. Make sure to properly ventilate the area. Try to keep all doors and

windows open. Also, try and setup some exhaust fans and keep all pets out of the area. If you are unable to properly ventilate the area, make sure to wear a respiratory mask and take frequent “fresh air” breaks. 2.

If your work requires you to do some sanding, make sure to wear a dusk mask and safety goggles.

3. Once you're done with your works, make sure to dispose of your

supplies the right way. Many paints and supplies are toxic and need to be disposed of at a toxic-waste dump. 4. Make

sure

to

check

the

label

and

follow

all

manufacturers’

instructions.

Prepared by:



Page |5


Marc Oliver Ybañez



Page |6

Epoxy Floor Coating Methodology

Recommend Documents