Christmas Bell Ornament Directions Step 1: Print out all 5 pages of the bell ornament.
Christmas Bell Ornament Christmas Bell Ornament Christmas Bell Ornament
page 3 of 5 Step 2: Fold each bell along the center dashed line and cut out the bell along the outer dashed grey line. Do this for all 4 bells. Then cut out both of the round clappers.
Step 5: Cut a thin piece of ribbon or string about 14 inches long. Place the ribbon or sting onto the glued surface as close to the middle as possible. Place it so that about an inch and a half sticks out at the bottom of the bell and the rest sticks out of the top.
Christmas Bell Ornament Directions
page 4 of 5
Step 6: Place another bell (picture side up), onto the bell with the glue and string. Make sure the edges line up, then push down to stick the bells together with the string between them. Fold back the 2 flaps that are not glued together.
Step 7: Place another bell (picture side down) on a table or flat surface. Spread glue onto the right half of the bell. Next, place the long half of the ribbon or string onto the glued surface as close to the middle as possible, this should create a loop between the bells.
Step 8: Place the fourth bell (picture side up) onto the bell with the glue. Press down so that the ribbon sticks between those 2 bells. Fold back the flaps that are not glued together.
Step 9: Spread glue over the remaining blank sides of the bells. Then bring the bells together so that the edges match up. Press firmly so the bell stays together.
Christmas Bell Ornament Directions Step 10: Place the clapper (picture side down) on a table or flat surface. Spread glue on the blank side, then press the ribbon that is sticking out of the bottom of the bell into the glue. Last, place the second clapper (picture side up) on top of the other clapper. Your ornament is finished!
Christmas Reindeer Ornament Step 1: Print out all 4 pages of the reindeer ornament.
Christmas Reindeer Ornament
page 3 of 4 Step 2: Fold each piece of the ornament along the middle dashed line so the picture is on the outside. Next cut out all 3 reindeer ornament pieces along the outer dashed line.
Step 4: Unfold one ornament piece and place it (picture side down) onto a table or flat surface. Cover the left side of the ornament piece with glue. Place the end of the ribbon or sting into the glue as close to the center of the ornament as possible and press down firmly.
Christmas Reindeer Ornament Step 5: Place the second ornament piece (picture side up) on top of the ornament piece with the glue. Make sure the pieces line up and press down so the ribbon is stuck between the two ornament pieces. Then, fold back the flaps that are not glued together.
page 4 of 4 Step 6: Spread glue onto the remaining white flaps of the ornament, then press the last reindeer piece of the ornament into the glue so that the edges match up. Your ornament is finished!
