Copper tube and fittings shall be joined (Soldered, Brazed, flared joint or compression type) in accordance with the procedures and techniques specified in Copper Tube Handbook of the Copper Development Association, IAPMO IS 3-93
A2
Fitting shall be in accordance with ASME B 16.22 for solder or brazed joint.
RTSAES-L-105 Section 12 Line Class Tables
A3
Copper tubing (Line Class 12BC0U) shall not be used for firewater system in blast resistant control buildings Note: 12 BD0U or approved equal shall be used for firewater system in blast resistant control building
RTSAES-L-105 Para 12.2
A4
Copper tube below ground shall be type "K".
A5
Copper tube for water piping shall have a weight of not less than Type "L"
RTSAES-S-060 Para 604.2
A6
Connections between Cement lined Carbon steel(12LC0U) and 12BD0U or 12BC0U shall be made with an isolation gasket, such as Pikotek or equal, or a dielectric union Note:Cathodic protection, if provided, must be on separate circuits for the different materials. Care must be taken to assure that the isolated joint is not short-circuited by pipe supports
RTSAES-L-105 Para 12.2.1
A7
Connections between cement-lined steel pipe and the same size CopperNickel pipe shall be made with an isolated, flanged joint in accordance with Saudi Aramco Standard Drawing AA-036865. Note: The raised face of the cement-lined steel flange shall be machined off to accommodate the connection to the flat-faced CopperNickel flange.
RTSAES-L-105 Para 12.2.2
A8
Connections between a larger cement-lined steel header and CopperNickel pipe shall be accomplished with special cement-lined, flanged tees with a 4-inch minimum size branch.
RTSAES-L-105 Para 12.2.3
A9
Connections between any dissimilar metals shall be by means of a dielectric or insulating union.
A10
The flanged branch connection to the Copper-Nickel pipe shall be isolated in accordance with Saudi Aramco Standard Drawing AA-036865. Note: Copper-Nickel reducer may be used to obtain the desired pipe size. Welding bosses shall not be used.
PASS
FAIL
N/A
RE-INSP DATE
RTSAES-S-060 Para 316.1.7 b
RTSAES-L-105 Section 12 Line Class Tables
RTSAES-S-060 Para 604.11.2(b)
RTSAES-L-105 Para 12.2.3
REMARKS:
REFERENCE DOCUMENTS: 1-RTSAES-S-060 -- Overlay of SAES-S-060 -- Saudi Aramco Plumbing Code, 28 January, 2004 2-RTSAES-L-105-- Overlay of SAES-L-105 -- Piping Material Specifications, 30 September, 2003
Subcontractor / Contractor
Company
Work is Complete and Ready for Inspection: Name, Initials and Date:
Name, Initials and Date:
Subcon QC Inspector
T&I Witnessed
QC Record Reviewed
Work Verified
T&I Witnessed
QC Record Reviewed
Work Verified
PID Representative
Performed Inspection
Work / Rework May Proceed
Name, Initials and Date:
Name, Initials and Date:
Contractor QC Inspector
Y = YES N = NO F = FAILED
Performed Inspection
Work / Rework May Proceed
Name, Initials and Date:
Contractor Qc Supervisor Quality Record Approved Name, Sign and Date: * Person Responsible for Completion of Quality work / Test
