A BASIC IDEA ON THE HINDU WARRIOR ASCETICISM IS DISCUSSED.
Wealth WarriorFull description
Wealth WarriorFull description
Full description
A Tutorial on Fuzzy C Means, covering alternating optimization, comparison with K-Means and Gaussian Mixture Models, gradient derivations.Descripción completa
When the daughter of a retired Navy SEAL is kidnapped and held for ransom in Mexico, Rogue Warrior Richard Marcinko and his band of Red Cell International warriors head south of the border t…Full description
Warhammer chaos warrior homebrew for D&D 5e
tacfit warrior manual from videosDescrição completa
CodeWarrior for HCS12 C Programming 1) Start CodeWarrior for HCS12, close the Tip of the Day if it comes up, and select New from file menu as shown below.
2) Select HC(S)12 New Project Wizard, Set the location where the project is to be saved, and name the project as shown below, then click Next.
3) Click Next at the Welcome screen shown below.
4) Select the MCU to program as shown below, then click Next.
5) Select C as the programming language as shown below, then click Next.
6) Select No for Processor Expert as shown below, then click Next.
7) Select No for PC-lint as shown below, then click Next.
8) Select minimal startup code as shown below, then click Next.
9) Select None for floating point as shown below, then click Next.
10) Select Small for memory model as shown below, then click Next.
11) Select Full Chip Simulation and a hardware debugger as shown below, and click Next.
12) Expand the Sources folder created by CodeWarrior and double click main.c as shown below. CodeWarrior provides a template to begin the program, see the full template below the graphic.
#include /* common defines and macros */ #include /* derivative information */ #pragma LINK_INFO DERIVATIVE "mc9s12dp512" void main(void) { /* put your own code here */ EnableInterrupts; for(;;) {} /* wait forever */ /* please make sure that you never leave this function */ }
13) Replace the template code with an example from the book as shown below or your own code. Note that the minimal requirements for a C program are the header file, that defines the registers of the MCU, and the function void main(void) {…} with a blocking function at the bottom or the program should be an infinite loop.
// Code from Example 7-2 used in this tutorial #include /* derivative information */ void main(void) { unsigned char mynum[]= "012345ABCD"; //data is stored in RAM unsigned char z; DDRB = 0xFF; //make Port B an output for(z=0;z<10;z++) PORTB = mynum[z]; while(1); //stay here forever }
14) Select Full Chip Simulation in the drop down box, then hit F5 to debug. See the Debug Tutorial for details.
