Manual de servicio motores MitsubishiDescripción completa
Descripción: Artículo sobre cultura y violencia política. Reflexiones sobre la indumentaria de los presos por terrorismo de sendero luminoso, visto como parte de una pauta cultural. En revista "Segunda piel". P...
kinematics
thinkiit
Examen diagnostico Tecnología de la InformaciónDescripción completa
mm
historialDescrição completa
Descripción completa
thinkiit hcverma hindi
Descripción completa
Integracion tics
Descripción completa
TICS PUMP ELECTRICAL PART RESISTANCE VALUE LIST
FOR MITSUBISHI
1. OBJECT
Pre-stroke actuators and governor actuators on TICS pumps produced after April 1995. REDIII governor part no.: 10595 * - * * * * - applicable REDIV governor part no.: 10596 * - * * * * - not applicable
2. NOTES
(1) The resistance values mentioned are the specified values from the drawings (without wire harness resistance). The values listed were measured at an ambient temperature of 25°C. When measuring the actual values, the measured values may differ from those listed due to the influence of the ambient temperature at the time of the measurement, the temperature of the object being measured, differences in the measuring instruments, differences in the measuring methods used, or whether or not wire harnesses are attached. Small differences between actual values and specified values are most probably due to the reasons mentioned above. Those measured resistances alone cannot be used to conclude that there is a fault. Use together with service manual below (refer to inspection item). Governor actuator Pre-stroke actuator
Pub. No. EE13E-11152 GOVERNOR MODEL REDIII Pub. No. EE11E-11220 FUEL INJECTION PUMP MODEL TC(S).MD Pub. No. EE11E-11230 FUEL INJECTION PUMP MODEL TC(S).HD
(2) When measuring insulation resistance, always use the insulation resistance tester. (3) The pump assembly numbers mentioned are the main assembly numbers. If you cannot find the pump assembly number your are looking for in the TICS pump part number list, search for the actuator part numbers on the governor actuator pages or the pre-stroke actuator pages. 3. OTHERS
(1) Wire harness colors R
Red
B
Black
BW Black/white
W
White
L
Blue
BR
Black/red
Y
Yellow
O
Orange
BY
Black/yellow
G
Green
Br
Brown
(2) 'hous.' in the insulation resistance column refers to the housing. (3) In this list, the resistance in the insulation resistance column described as 'Above 10MΩ' actually means 'not less than 10MΩ'. (4) Contact Bosch Corporation, JA/MKT1 if there are any mistakes or omissions.
TICS PUMP PART NO. LIST Governor actuator Part number Ref. no
