Lucanus Swinhoei Model & diagram
©
Pavel Nikulshin
Paper : : Monocolor Side of square : 70 cm Density of paper : / m 2 : 6 0 g Email
[email protected]
Made in Russia
Unfold to step 11.
Fold on lines.
Reverse-fold two corners.
Reverse-fold two corners.
Fold and unfold own layer.
Reverse-fold two corners.
Fold and unfold own layer. Open -sink.
View from above.
Repeat steps 30-33
30-33
from the front and behind.
Fold the edge in i n to the center, spread-sining top and bottom. Fold the edge back out to the side.
Sink the long edge, closed at top and bottom.
Fold the edge in to the center, spread-sining top and bottom.
Fold the edge back out to the side.
Sink the edge, closed at top and bottom.
Repeart step 35-40 to behind.
Fold own layer on the right.
Fold own layer on the left.
Fold own flap up.
Sink the long edge, closed at top and bottom. Fold and unfold one layer.
Sink the edge, closed at top and bottom.
Fold the flap down. To raise the top layer.
Sink the edge, closed at top and bottom.
Fold own flap up.
Repeat steps 35-51.
35-51
Fold down the small corner corner.. Sink the corner.
Fold own layer on the right. Repeat steps 35-40 from two sides. Fold own layer on the left.
Fold own flap up. Repeat steps similar 35-40. 35-40. Fold own flap up.
Repeat steps 45-47. Fold two flap down. Repeat steps 59-63.
45-47
59-63
Fold one flap down. Fold and unfold one layer.
Pressed from each side to shift up the top layer. Closed sink fold.
Fold own flap up.
Fold one flap up on each side, and fold two flaps down behind.
Fold and unfold one layer. Pressed from each side to shift down the top layer.
Open sink corner corner..
Pleat fold. Position of lines to determined by sight.
Pleat fold. Position of lines to determined by sight.
Open the top layer.
Fold and unfold own layer.
Closed sink fold. Closed sink fold.
Repeat steps 87-91.
Open.
87-91
Crimp the six leg.
Crimp the leg.
Closed sink fold.
Repeat steps 101-102 behind. Reverse-fold the corner.
101-102
Reverse-fold the corner.
Reverse-fold the remaining bit. Narrow the foot and give it a half-twist.
Crimp the leg.
Repeat steps 103-107.
Repeat steps 103-107 in front. 100-107
Repeat steps 100-110.
103-107 100-110
To form thorn.
Open on the middle.
Unsink.
Repeat steps 113-115. Open on the middle.
113-115
Unsink.
Unsink. To pull from marked points.
To form thorns.
Repeat steps 118-123.
118-123
Open on the middle. To pull from marked points. poi nts.
Unsink
To form thorns.
Repeat steps 126-131.
126-131
The top layer is not shown . Reverse-fold the corner .
Reverse-fold the corner .
Reverse-fold.
Reverse-fold the remaining bit.
To pull from marked points.
Repeat steps 134-145. 134-145
Shift the layer from behind .
To form the horn.
Fold own flap up. Make some small pleat folds. Mountain fold.
Fold own flap doun.
Make two small pleat folds.
To give model the finished form.
Finished.
