sanitary landfill thesis guide

Rehabilitation of Sanitary Landfill: References: 1. Republic Act 9003 “Ecological Solid Waste Management Act of 2000” 2. DENR Administrative Order on Water Effluent and Water S tandard 3. National Building Code of The Philippines 4. Electrical Code of the Philippines 5. Sanitary Code of the Philippines 6. National Structural Code of the Philippines 7. Republic Act 6969 “ Toxic and Hazardous Waste” 8. IEE/EIA Report 9. Environmental Geo-hazard Assessment Report 10. ECC Copy 11. WACS 12. Geotechnical Report 13. Monitoring Report (Air Sampling and Water Sampling)

Data Needed: 1. Waste Volume Generation on a daily basis. 2. Volume of waste to be dump in the landfill (for airspace computation, this refers to the capacity of the landfill and its lifespan) 3. Monitoring Report: a. Air Sampling b. Water Sampling (Ground Water and Surface Water) 4. Annual Rainfall Intensity (to be used in the computation of leachate generat ion) 5. Leachate Production (to be use in sizing the leachate collection pipe and leachate pond) 6. Leachate Characteristics (to be used in de signing the Leachate Treatment Facilities) 7. Characteristic of waste , determining the volume of compostable (to be use in sizing the composting facility) 8. Topographic Map 9. TCT Landfill Components including structures needed: 1. Administration Building 2. Weighing Scale 3. Material Recovery Facility 4. Composting Facility 5. Roads (Internal Road, refer to the access road within the site) 6. Landfill Cell 7. Leachate Pond and Treatment Facility Facility if needed

8. Leachate Collection Pipe, this refers to the pipe installed in the base of the landfill to convey leachate generated by the landfill. 9. Gas Collection System, as per RA 9 003, this is required upon attaining a volume of 500,000 cu.m. of waste. 10. Final Soil Cover /Final Capping 11. Electrical Lay-out 12. Other requirements stated in the ECC documents. Suggestion: 1. Limit your study in the Design of the L andfill Cell 2. Do not design the Leachate Treatment Facility , just make sizing of le achate pond -

Monthly Rainfall intensity is needed in sizing the pond

3. Prepare drawings: -Topographic Map - Site Development Plan , showing all the components - Cross Section of Landfill Cell - Liner System of the Landfill - Leachate Collection Pipe Lay-out - Gas Collection System - Internal Access Road All other drawings like MRF and Administration would only be As-built drawing