METHOD OF STA STATEMENT
Fiber Optic Testing and Termination
Fiber Optic cable Testing procedure Using Arc FusionSplicer-FSM-60S Fiber optic cable fusion splicing provides the lowest-db loss. Special equipment called Arc fusion splicer is used to perform the ber fusion splicing. High precision arc fusion splices are using to achieve lowest db loss. This equipment can be used for dierent t!pe of ber"s S#$ ##%.etc.
Fiber optic cable splicing procedure &. Glanding- 'roper clamp or gland will be used to secure the ber cable. (. !reparation-)emove all the '*+ insulation and armored sheathing. 'ut the ber cable in to the ber shelf. ,. Sur"ace #leaning-se a ell! or other cleaner to clean the ber cable. /. #leaning-+lean the ber cores with pure 01123 alcohol. +lean the ber with high qualit! alcohol because dust partials from the ber coating surface can be enter inside the protection sleeve and might result in a future ber brea4.
5. Slee$es - 'lace the required length protection sleeve each core
carefull!. 6. Fiber Stripping - )emove outer coating of ber cores required length as per ber t!pe with a precision stripping tool. +lean the bared ber core with pure 01123 alcohol.
7. #lea$ing- Set the stripped ber on the cleaver to cleave the ber. 'roper cleaving is a main important step for a good result.
8. Start- +lean the equipment before starting the wor4. se select mode for determine ber cable t!pe if ber t!pe is not identied to select Auto splice mode.
1. Mounting-Set the cleaved ber core onto the ber holder with protruding required length as per the ber t!pe &9.
&&.
Align%ent & Splicing-:oading the ber to the arc Fusion
splicer between the v-groove edge and tip of electrode. After completion of ber automatic alignment arc discharge is performed to splice the bers.
&(.
Splice 'oss-;stimated splice loss is displa!ed upon
completion of splicing. Splice loss is aected b! certain factors.
&,.
. #a4e sure the splice point is located at the center of the
protection sleeve.
&/.
'lace ber with protection sleeve in the center of the tube
heater. The heating c!cle starts automaticall! as soon on the tube heater is closed.
&5.
Ta4e out the protected sleeve ber core from the tube heater
and put inside ber splice tra!. Arrange spliced ber core properl! in the shelf.
F()E* O!T(# #A)'E TEST(NG !*O#EDU*E US(NG AN*(TSU A##ESS MASTE* OTD* + MT-,0.A + 06./Optical Ti%e De%ine *eect Meter i.
ii.
tested. +onnect one end of the Fiber to the near end adaptor of the
iii. iv.
testing equipment. 'ress the start button to test the Fibers. Testing will be carried out automaticall! b! the testing
v.
equipment. wave length will be used b! the test equipment =859nm >
vi.
&,99nm? Test result$ both graphical and test values$ will be saved to the
vii.
test equipment for later printing. To save the correct test report$ enter the cable description as
viii.
required. The result will be printed with the below given details. db loss +able length )eference db
i.
General
The OT<) Function provides the capabilit! of #easuring connection loss$ ber loss$ and distance of an Optical Fiber .Bou can :ocate
