Descripción Sistema de Frenos FordFull description
Ini adalah tugas mata kuliah Teknologi Motor Bensin tentang Exhaust Brake.
Materiales para frenos
Ini adalah tugas mata kuliah Teknologi Motor Bensin tentang Exhaust Brake.
volvoFull description
Descripción completa
BR02–106
SERVICE BRAKE
(3) Unit: mm
138 102.1 30
Under the status status that the the speci special al tool tool remain remains s pushed pushed against against push rod guide, piling washers on the depression for adjustment at the end-face of special tool and picking out one top washer piled up, determine Max. quantity of washers, installable in the internal diameter of base.
NOTICE The washer quantity at this time is adjusted one for setting dimension of push rod guide. Accordingly, keep them securely. securely.
0 7 3 3 3 1
THE SURFACE TO CHECK DIMENSION DEPRESSION FOR WASHER ADJUSTMENT SHTS068020200175
HINT
• • •
Do not mind to use the washers picked out in dismounting. Target for washer quantity: 0-4 pcs. Washer thickness (1 pierce): 0.5 mm {0.02 in.}
(4)
Picking Picking out specia speciall tool and push push rod guide guide for for a while while and installinstalling the washer of quantities determined in the above (3) and new tolerance ring on push rod guide, insert it deeply with special tool again until push rod guide contacts with the bottom. NOTICE
• •
Be careful not to drop off the washers.
(5) (6)
Exhau Exhaust st the the air air of park parkin ing g brake brake sid side e port. port. Apply Apply grease grease at the the depress depression ion portio portion n of push rod guide. guide.
After installing, confirm that, under the status that the special tool remains pushed against push rod guide, the endface of base side is almost identical with the surface to check setting dimension of special tool.
Using grease: COSMO Heat-resistant grease B No. 2 or equivalent. 7. (1)
BREATHER TUBE ELBOW
INST INSTAL ALLA LATI TION ON OF BREA BREATH THER ER TUBE TUBE Insert Insert new filter filter into into the tip of of breather breather tube, tube, after after which which it should should be inserted into elbow. In this case, make sure that the hose bulge should come to the center between two protuberant portions, located at the end of elbow.
NOTICE
SHTS068020200223
•
Pay attention to the direction of filter. (Its small path side should be tube side)
•
When inserting breather tube into elbow, do not apply any grease or the like.