material verification api rp 578Descripción completa
Full description
MANUAL MANITOU MHT 10160Full description
Business Statistics
Different between SA 537 Cl2 vs 841 Cl2
Full description
Full description
Full description
Alloy Composition of MaterialsFull description
pagsusuri
Full description
Alloy Composition of MaterialsFull description
Descripción: COMPARISON OF STANDARDS NFPA 13 and EN 12845
Proyekto sa espFull description
Comparison of ultrasonic test method and acceptance criteria between SA 578 & BS EN 10160
1. 2.
3.
4.
5.
SA 578 Plain and clad steel plates of 10mm and above. Sensitivity is adjusted by back wall echo set to 50 – 80% FSH
SA 578 S1 specifies 100% scanning. Acceptance criteria may be Level A, B or C depending on the requirements. For Level C acceptance criteria, an 2 area of approximately 490mm (25mm diameter circle) or less is acceptable. For Level A & B, an area of 2 approximately 4415mm (75mm diameter circle) or less is acceptable.
BS EN 10160 Nominal thickness range 6mm to 200mm. Sensitivity is adjusted by flat bottom holes as 6mm; 8mm or 11mm. so you have to prepare at least 6 blocks or steps in the thickness range of your plate with 8mm & 11mm diameter flat bottom holes for S 2 and E2 quality classes. Alternatively DGS scales can be used for UT machines which support DGS. EN 10160 quality class S 2 & E2 specifies 100mm square grids scanning. S2 quality class does not specify any area for single indication; if the indication exceeds 11mm reference curve, it is straightway rejected.
For quality Level B, two or more 2 discontinuities smaller than 4415mm (75mm dia. Circle) shall be unacceptable unless separated by a minimum distance equal to the greatest diameter of the larger discontinuity or unless they may be collectively encompassed by the circle of 75mm diameter.
For clusters of discontinuities, a maximum of 10 numbers of indications whose signals lies between 8mm and 11mm reference curve in a 1m x 1m square area of the plate are acceptable.
For checking of bond integrity, SA 578 specifies special supplementary requirements as S6 & S7, which refers to material specifications of S 263; 264 & 265 accordingly.
Checking of bond integrity is not specified in BS EN 10160.