Origami Flower

Materials Scrapbooking Paper Scissors Glue Paper Clips

      T       F       A       R       C       R       E       S       I       A       K

Origami Flower

vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv 

 Th  Th Orgam wr is a fn nd vrsatl vrsatl ppr crft t mke. Ethr as a cut prsnt   tr r mke a bnch with wr stlks nd ppr lvs.

PAPER CRAFTS

www.kaisercraft.com.au

1

Materials Scrapbooking Paper Scissors Glue Paper Clips

      T       F       A       R       C       R       E       S       I       A       K

3D Flower Ball

vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv 

 Ths imprv Flwr ba is md from 12 Orgam wrs, mkng sr a edges f ech wr r cctd t nothr. Ths dcratn is prfct fr n occasin whthr it b Chrstms r Brthdy. Ti rn through n f th edges nd dcrat with rn ts, mke n gold ppr nd use as a niq str fr yor tr r nsrt a stck fr a cut tpr  tr.

PAPER CRAFTS

www.kaisercraft.com.au

2

1: Cut 5 100 mm x100 mm squares.

2: Using one piece o paper at a time, ace the right side downwards. Fold the bottom corner up to the top to make a triangle. NOTE: Each 100 mm x 100 mm square makes one petal.

3: Bring the side points up to the top point so that it makes a diamond.

4: Fold back the top 2 layers layers outwards so that the edges that that were running vertical in the centre, now line up with the corner sides o the square underneath. I you have olded it correctly you should have 2 horizontal edges, as shown in the second image.

5: Open up your newly ormed triangles and old down onto themselves so that the old corner old line is now in the centre o a kite shaped s haped top layer.

6: Fold the points o the kites inwards so that the corners align with the square underneath.

7: Fold the kites in hal again, over existing creases. Once olded, glue the 2 outside aces together together..

8: Your nished petal should look like image shown. Repeat steps or all 5 sheets o paper and glue each petal together. together. Use paperclips to hold together sides whilst glue drys NOTE: To To make 3D fower Ball, repeat origami fower 12 times.

PAPER CRAFTS

www.kaisercraft.com.au

3