GUÍA DE LA ESTACIÓN TOTAL LEIKADescripción completa
Full description
ultraaaaFull description
Descripción completa
Descripción completa
Full description
Manual para hacer Levantamientos , Replanteos, Linea referencia y descarga de datosDescripción completa
Leica GPS System 500 Release * Sensor firmware V5.10 * (C) Copyright 1998-2004 Leica Geosystems AG All rights reserved. Dear
customer,
if the firmware upload failed for some reason and if you have the following messages displayed on the TR500 terminal when you switch on the Sensor (after 10 sec), =============================================== Error Following error detected during startup: * Invalid Firmware Please download new firmware =============================================== then please press the F2 - LOAD function Terminal.
key
on
the
The Terminal displays now the message: =============================================== TRANSFER waiting for serial download =============================================== Detach the terminal from the receiver and connect the Sensor to the PC with the Leica serial port data transfer cable. Please note that you have to connect the cable directly to the Sensor's terminal port and NOT to the terminal itself. Remove the terminal off the Sensor! You do not need the terminal for serial Sensor firmware upload. Connect the cable to an RS232 port of your computer (normally COM1) and connect it to the TERMINAL port of the Sensor. Disconnect all external devices from the sensor modems etc)
(radio
Remove the PC card Make sure sensor
you
have fully charged
batteries
in
the
Copy the 5_sen.fw file to your harddisk. Note, for this failure upload process you have to use SKIPro software or LGO version 1.00 software. IN case you do not have this Software version available,
please contact your local technical support. Start SKIPro/LGO (ver 1.0) now. Using SKIPRo: Select Tools - Sensor Transfer. In the tree view, click with the right mouse button on the folder Sensor. Use the context menu item "Settings" to specify the used COM port of your computer and set a baud rate according the performance of your computer. Having correctly connected the Sensor to the PC, click with the right mouse button on the folder PC in the tree view, and choose "New Location". Select the directory where you have previously copied the 5_sen.fw firmware file. This directory will be added as a new folder to the tree view. Then open the new folder and and the sub-folder "Firmware Sensor". First click "5_sen".
with the right mouse button on
the
item
Choose "Send to: Sensor System" from the context menu. Depending on the selected baudrate the transfer can last between 10-30 minutes. During the transfer, DO NOT activate or use any other software on the PC. When using LGO,select Tools - Software Upload. Upload the 5_sen.fw firmware file by following the instructions of the Upload wizard. For further details, please refer to the LGO Help (Chapter "Software Installation-Sensor/System firmware") The Sensor can now be turned off using the command "Turn GPS Sensor off" (right mouse-click on Sensor folder). Alternatively you could press the ON/OFF button of the Sensor itself. Disconnect the data transfer cable from the sensor attach the terminal to the sensor. Turn the Sensor on and the system should now start showing V5.10 in the "Leica Geosystems" screen. You can now selecting:
