This document consists of the matlab code that plots the sensitivity of a rogowski coil with respect to various parameters.Full description
Process engineering guide
Descripción completa
Process Control TextFull description
DESIGN AND SIMULATION OF A MARINE PROPELLERFull description
A comparison study of heat exchanger design using two methods of approach of manual calculations and using HTRI Software.Deskripsi lengkap
A comparison study of heat exchanger design using two methods of approach of manual calculations and using HTRI Software.
htri, tutorial, operaciones unitarias, transferencia de energía térmica, calor, intercambiadores de calorDescripción completa
This is the best book so far
This is the best book so farDescripción completa
Aspen Exchanger Design and Rating _HTFS+_ Rev.0 (1)
Descripción: Heat Exchanger Selection Rating and Thermal Design by Sadık Kakaç, Anchasa Pramuanjaroenkij, Hongtan Liu. Second Edition
Description complète
Full description
Modeling and SimulationFull description
hysys simualation
Modeling and Simulation Lab Manual for Final Year ECE Under Anna University of Technology, Coimbatore
HTRI
sedikit tentang rating HTRI di Komponen PembangkitFull description
Design, Rating and Simulation are three modes of cal in HTRI (or in any other hex software) Design Mode You input the process conditions required and leave the geometry of the exchanger open (with some basic input plugged in like - fluid allocation in shell/tube side, TEMA type, max tube length, max allowable dp, fouling etc) Simulator will give you various options of geometry in a tabulated form. Rating Mode You plug in detail geometry of the exchanger, plug in required process parameters and in/out temp required. Simulator will predict performance of the exchanger- % over design, calculated pressure drop, vibration levels. Simulation mode It is same as rating mode, except you do not specify outlet temperatures of the hot & cold fluids. By iterative calculation simulator will arrive at a condition where all the available area is utilized, and under this condition it will predict the outlet temperatures of the hot & cold fluids.
