Comandos Huawei

Comandos Cisco

> >enable #

Comandos Huawei

< > modo user ( no se puede configurar ni rebotear) >system-view [ ] modo system (se puede puede configurar, configurar, no tracea)

no show version show log show interface xx show ip interface brief  sh ip route

undo >display version >display logbuffer  >display interface xx >display ip interface brief  >display ip routing-table (protocol xx)

 ping x.x.x.x tracert x.x.x.x

>ping  – a y.y.y.y (LAN)  – c (n° paq.) x.x.x.x (Destino) >tracert  – a y.y.y.y (LAN) x.x.x.x (Destino)

show running (ram) show config (flash)

>display current-configuration (ram) >display saved-configuration (flash)

clear counters

>reset counters interface

write reload

]save (en modo system view) >reboot

show frame-relay pvc sh ip bgp summary

>display fr pvc-info >display bgp peer  >display bgp routing (ruteo bgp)

sh policy-map (ver menu)

>displ qos policy (ver menu)

debug x terminal monitor  terminal debug

>debugging x > terminal monitor  >terminal debugging -Multicast IGMP (mantiene el grupo multicast, protocolo de control) >display igmp interface >display igmp routing-table PIM-DM (protocolo de ruteo multicast, establece camino) >display pim neighbor 

Table 3-13 Displaying the router configuration Operation Command Display the startup configuration of the router  display saved-configuration Display the current configuration of the router  display current-configuration [ controller | interface interface-type [ interface-number ] | configuration [ bgp | ospf | post-system | rip | system | user-interface ] ] Display the running configuration in the current view display this

Table 3-14 Saving the current configuration Operation Command Save the current configuration save [ cfgfile ]

Table 3-15 Erasing the configuration file in the storage devices Operation Command Erase the configuration file in the storage devices reset saved-configuration

Table 3-16 Configuring the file name of the system software used for the next startup Operation Command Configure the file name of the system s oftware used for the next startup startup system-software sysfile [ slave-board ]

Table 3-17 Configuring the name of the configuration file used for the next startup Operation Command Configure the name of the configuration file used for  the next startup startup saved-configuration cfgfile

Table 3-18 Displaying the information of the file used at startup Operation Command Display the information of the file used at startup display startup

Antes de copiar una nueva configuración en Huawei. 1) 2) 3) 4) 5) 6)

reset saved-configuration apagar el equipo volver a encenderlo ingresar en modo SYS y copiar la configuración salvar la configuración con save verificar configuración con dis cu

interface GigabitEthernet3/0/2 description ACCESO_NODOB_Linea:5663653/4/5_CCOESTE_TE0/4/0/0.29023501  port hybrid pvid vlan 2902 undo port hybrid vlan 1  port hybrid untagged vlan 2902  port vlan-stacking vlan 101 to 200 stack-vlan 2902  port vlan-stacking vlan 3501 stack-vlan 2902 stp disable stp edged-port enable qos pq 5 wrr 0 to 4 6 to 7 qos queue 0 wrr weight 80 qos queue 2 wrr weight 20 undo negotiation auto #