This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this st...
ASTM C150 - Standard Specification for Portland CementFull description
ASTM C 151 - 2005 - Standart Test Method for Autoclave Expansion of Hydraulic CementFull description
ASTM C115M-10 Standard Test Method for Fineness of Portland Cement by the TurbidimeterDeskripsi lengkap
D6677
ASTM D523-08Full description
HSSSSFull description
ASTM D523-08
Full description
D6677Full description
Descripción completa
ASTM D523-08Full description
Full description
Full description
Provee una actualización de los métodos de detallado de estructuras según las ultimas normas americanas.
Practicas de coagulacion y flocualcion
Descripción completa
22/6/2016
15 Standar d Test M ethod for Fl ow of Hydr au aul i c Cement Mor tar
15 Standard Test Method for Flow of Hydraulic Cement Mortar Significance and Use 3.1 This test method is intended to be used to determine the flow of hydraulic cement mortars, and of mortars containing cementitious materials other than hydraulic cements. 3.2 While flow is not usually included in hydraulic cement specifications, it is commonly used in standard tests that require the mortar to have a water content that provides a specified flow level. 1. Scope 1.1 This test method covers the determination of flow of hydraulic cement mortars. 1.2 The values stated in SI units are to be regarded as the standard. No other units of measurement are included included in this this standard. When combined standards are cited, the selection of the measurement systems is at the user’s discretion subject to the requirements of the referenced standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately)
ASTM Standards C109/C109M Test C109/C109M Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens) C185 Test C185 Test Method for Air Content of Hydraulic Cement Mortar C230/C230M Specification for Flow Table for Use in Tests of Hydraulic Cement C230/C230M C511 Specification for Mixing Rooms, Moist Cabinets, Moist Rooms, and Water Storage Tanks Used in the C511 Testing of Hydraulic Cements and Concretes Keywords Flow - Flow Rate - Hydraulic Cement - Mortars ICS Code ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar) UNSPSC Code UNSPSC Code 30111504(Mortars) Referencing This Standard https://ww w.astm .or g/Standar ds/C 1437.htm
1/2
22/6/2016
15 Standard Test Method for Flow of Hydr aulic Cement Mortar
Link HereLink to Active (This link will always route to the current Active version of the standard.) DOI: 10.1520/C1437-15
ASTM International is a member of CrossRef. Citation Format ASTM C1437-15, Standard Test Method for Flow of Hydraulic Cement Mortar, ASTM International, West Conshohocken, PA, 2015, www.astm.org
