These miniatures are supplied in two forms. One page contains all of the Flat / A-frame miniatures, and the other two pages have the triagonal miniatures on them. These can be assembled into three different forms, and full instructions are given below.
1
Cut out the flat miniatures, including the hatched base panels:
2
Gently score along the short horizontal lines with a blunt blade.
3
Fold the miniature along the score lines so that it looks like this:
4
Apply paper glue to the insides of the figure panels.
5
Press glued panel together and ensure they stick. Use a paper clip or hold for a minute if necessary.
6
Apply glue to the reverse of the hatched panel. Press panel against base of miniature.
7
Use a paper clip to keep the miniature closed until the glue is dry.
Print out as many pages as you need of your preferred type, preferably on 160gsm card, cut, glue and use.
Credits: Produced by Graham Bottley Created using the Poser 6 program from Curious Labs. Models used mainly from DAZ3D. (www.daz3d.com). The Darcassian is from X2000, Textures from Daz3D and John Malis.
ASSEMBLY INSTRUCTIONS Triagonal Miniatures
A-Frame Miniatures
1
Cut the triagonal miniatures out so that the blank panels are to the right of the three filled panels.
1
Cut out the flat miniatures, cutting off the hatched base panels:
2
Using a blunt blade, gently score along all of the upright lines.
2
Gently score along the short horizontal lines with a blunt blade.
3
Fold along all of the score marks so that the miniature looks like this:
3
Fold the miniature along the score lines so that it looks like this:
4
Apply paper glue to the blank base flap.
5
Press glued panel to the back of the name panel.
6
Use a paper clip to keep the miniature closed until the glue is dry.
4
Apply paper glue to the outside of the blank panel. Press to the inside of the first filled panel.
5
Use a paper clip to keep the miniature closed until the glue is dry.
