ANSI API SPEC 16A - June2004 Specification for Drill through Equipment 3rd EditionDescrição completa
API STANDARD
Descripción completa
Python case studies for computer vision.Descrição completa
third edition exalted.
Full description
Deskripsi lengkap
Full description
Tests CAE level
Descripción: errata
Full description
Glenn D. White and Gary J. Louie “Lexicographer, n. A pestilent fellow who, under the pretense of recording some particular stage in the development of a language, does what he can to arrest its...
Arabic language course
Full description
Full description
3rd Edition 40k Ork Codex
First published in 1995, Intuitive Eating has become the go-to book on rebuilding a healthy body image and making peace with food. We’ve all been there—angry with ourselves for overeating, for our ...
Date of Issue: November 2004
(Modified) , Affected Publication: API Specification 16A/ISO 13533:2001 (Modified) , Specification for Drill-through Equipment , Equipment , Third Edition
ERRATA
Page 23, Table 12: The US Customary units for Nominal size 78 mm should be “3 1/16” rather than “3 1/8” Page 28, Table 16 (right-hand side):
For Type 16B Integral Hub Connections, 20,69 MPa (3000 psi), size 16 3/4: replace Ring Number “RX 73” with “RX 65” (see revised section of table below): Ring number
Designated size
Rated working pressure MPa
(psi)
Type 16B integral hub connections RX 45
7 1/16
RX 65
16 3/4
RX 73
21 1/4
RX 53
11
RX 57
13 5/8
RX 65
16 3/4
13,79
2 000
20,68
3 000
SUPPLEMENT
Page 81, Section B.1:
Add the phrase, “or earlier editions of API Specification 16A”, to the end of the first sentence (see complete sentence below): This annex defines the requirements for repair and remanufacture of drillthrough equipment originally manufactured in accordance with this American National Standard or earlier editions of API Specification 16A. Page 106, Section I.1:
Replace Section I.1 with the following: I.1 API Monogram Marking Requirements I.1.1
General
These marking requirements apply only to those API licensees wishing to mark their products with the API Monogram. In addition to the marking requirements found in Clause 9, the API Monogram shall be stamped on the product after the product description code (PDC) or alphanumeric code, followed by API 16A, the edition of Specification 16A to which the equipment was manufactured, and the manufacturer’s license number. Application of the API Monogram shall be per the manufacturers API Monogram Marking Procedure as required by API Specification Q1. I.1.2
Repair and remanufacture
The API Monogram shall only be applied to equipment originally manufactured under the API Monogram Program in accordance with this American National Standard or earlier editions of API Specification 16A. For repair and/or remanufacture marking requirements requirements see Clause B.7. If applied, the API Monogram shall be adjacent to the information required in Clause B.7.2.
