Section 12.2 Adjusting Valve Lash Adjust the valve lash as follows: 1. If adjustment is needed, unscrew the locknut. See Figure "Valve "Valve Lash Adjustment" . Turn the adjusting screw until the valve lash is correct. Use the exact settings given in the "Adjust To" column listed in Table "Valve Lash Adjustment" .
1. Adjusting Screw
2. Locknut
Figure 1. Valve Lash Adjustment
Note: When adjusting the valves, adjust to the exact exact setting. Use the range only for checking adjustment. 2. 3. 4. 5.
Tighten Tighten the locknu locknutt 50 N·m (37 (37 lb·ft). lb·ft). Check Check the valve lash lash again. Adjust Adjust again again if necessary. necessary. Install Install the cylinder cylinder head head cover covers. s. Remove the cranking tool (J 46392) from the inspection hole in the flywheel housing. 6. Replace the end cover on the inspection hole and tighten the bolts 25 N·m (18 lb·ft).
EPA04 MBE 4000 Workshop Manual Printed Sun Oct 04 2015 21:31:15 (DDC-SVC-MAN-0023) GMT-0600 (Hora estándar, América Central)
