longer version of This love by Maroon 5 piano sheet musicDescripción completa
Descripción completa
Lost Stars es una canción interpretada por el cantante de la banda Maroon 5, Adam Levine. Pertenece al álbum "V" de Maroon 5 y es parte de la banda sonora de la película "Begin Again"
longer version of This love by Maroon 5 piano sheet music
Sheet music
1
Descripción: Partitura de Sunday Morning by Maroon 5
longer version of This love by Maroon 5 piano sheet musicFull description
Test Preparation SheetDescripción completa
HEAT TRANSFERDeskripsi lengkap
Full description
Cheat Sheet for all the formulas in Shigleys engineering designFull description
Deskripsi lengkap
HEAT TRANSFER
PROBLEM S
5.1
a. How many 128 x 8 RAM chips are needed to provide a memory capacity of 2048 bytes? b. How many lines of the address bus must be used to access 2048 bytes of memory? How many of these lines will be common to all chips? c. How many lines must be decoded for chip select? Specify the size of the decoders.
5.2
A computer uses RAM chips of 1024 x 1 capacity. a. How many chips are needed, and how should their address lines be connected to provide a memory capacity of 1024 bytes? b. How many chips are needed to provide a memory capacity of 16K bytes? Explain in words how the chips are to be connected to the address bus.
5.3
A ROM chip of 1024 x 8 bits has four select inputs and operates from a 5-volt power supply. How many pins are needed for the IC package? Draw a block diagram and label all input and output terminals in the ROM.
5.4
A computer employs RAM chips of 256 x 8 and ROM chips of 1024 x 8. The computer system needs 2K bytes of RAM, 4K bytes of ROM, and four interface units, each with four registers. A memory-mapped I/O configuration is used. The two highest-order bits of the address bus are assigned 00 for RAM, 01 for ROM, 10 for interface registers. a. How many RAM and ROM chips are needed?
b. Draw a memory-address map for the system. c. Give the address range in hexadecimal for RAM, ROM, and interface. 5.5
An 8-bit computer has a 16-bit address bus. The first 15 lines of the address are used to select a bank of 32K bytes of memory. The high-order bit of the address is used to select a register which receives the contents of the data bus. Explain how this configuration can be used to extend the memory capacity of the system to eight banks of 32K bytes each, for a total of 256K bytes of memory.
5.6
A magnetic disk system has the following parameters: Ts = seek time; average time to position
the magnetic head over a track R= rotation speed of disk in revolutions per second N t = number of bits per track
N s = number of bits per sector
Calculate the average time Ta that it will take to read one sector. 5.7
Obtain the complement function for the match logic of one word in an associative memory. In other words, show that M i' is the sum of exclusive-OR functions. Draw the logic diagram for M i' and terminate it with an inverter to obtain M i .
5.8
Obtain the Boolean function for the match logic of one word in an associative memory taking into consideration a tag bit that indicates whether the word is active or inactive.
5.9
What additional logic is required to give a nomatch result for a word in an associative memory when all key bits are zeros?
5.10 Describe in words and by means of a block diagram how multiple matched words can be read out from an associative memory.
5.11 Derive the logic of one cell and of an entire word for an associative memory that has an output indicator when the unmasked argument is greater than (but not equal to) the word in the associative memory. 5.12 Consider a 32-bit microprocessor that has an on-chip 16 Kbytes four-way set-associative cache. Assume that the cache has a line size of four 32-bit words. Draw a block diagram of this cache showing its organization and how different address fields are used to determine a cache hit/miss. Where in the cache is the word from memory location ADCDE8F8 mapped?
5.13 Given the following specifications for an external cache memory: four-way set associative: line size of two 16-bit words: able to accommodate a total of 4K 32-bit words from main memory: used with a 16-bit processor that issues 24-bit addresses. Design the cache structure with all pertinent information and show how it interprets the processor's addresses. 5.14 A set associative cache has a block size of four 16-bit words and a set size of 2. The cache can accommodate a total of 4096 words. The main memory size that is cacheable is 64K x 32 bits. Design the cache
structure and show how the processor's addresses are interpreted.
Solutions For Selected Problems
5.1
Referring to the organization in Fig.5-4: (a) The total memory capacity = 2048 = 211
bytes The capacity of a one RAM chip = 128 = 2 7 bytes
The number of memory chips needed = 211 / 2 7 = 16 memory chips.
(b) To access 2048 ( e.g 211 ) bytes, 11 bits for addressing are needed. Each chip has capacity of 2 7 bytes 7 bits for addressing must be common to
all
chips. (c) We have 16 memory chip 4 selection bits are needed. The 4 selection bits are decoded to 16 bit an 4
5.4
× 16 decoder is needed.
(a) The total RAM capacity = 2K = 2048 =
211 bytes
The capacity of a one RAM chip = 256 = 28 bytes
The number of memory chips needed = 211 / 28 = 8 memory chips.
The total ROM capacity = 4K = 4096 = 212 bytes The capacity of a one RAM chip = 1024 = 210 bytes
The number of memory chips needed = 212 / 210 = 4 memory chips.
(b) The memory and I/O address map for the system is shown below: component
Address Bus
Hexadecimal address
13
12
11
10
9
8
7
6
5
4
3
2
1
0
RAM1
0000 – 00FF
0
0
0
0
0
0
X
X
X
X
X
X
X
X
RAM2
0100 – 01FF
0
0
0
0
0
1
X
X
X
X
X
X
X
X
RAM3
0200 – 02FF
0
0
0
0
1
0
X
X
X
X
X
X
X
X
RAM4
0300 – 03FF
0
0
0
0
1
1
X
X
X
X
X
X
X
X
RAM5
0400 – 04FF
0
0
0
1
0
0
X
X
X
X
X
X
X
X
RAM6
0500 – 05FF
0
0
0
1
0
1
X
X
X
X
X
X
X
X
RAM7
0600 – 06FF
0
0
0
1
1
0
X
X
X
X
X
X
X
X
RAM8
0700 – 07FF
0
0
0
1
1
1
X
X
X
X
X
X
X
X
ROM1
1000 – 13FF
0
1
0
0
X
X
X
X
X
X
X
X
X
X
ROM2
1400 – 17FF
0
1
0
1
X
X
X
X
X
X
X
X
X
X
ROM3
1800 – 1BFF
0
1
1
0
X
X
X
X
X
X
X
X
X
X
ROM4
1C00 – 1FFF
0
1
1
1
X
X
X
X
X
X
X
X
X
X
Interface1
2000 – 2003
1
0
0
0
0
0
0
0
0
0
0
0
X
X
Interface2
2004 – 2007
1
0
0
0
0
0
0
0
0
0
0
1
X
X
Interface3
2008 – 200B
1
0
0
0
0
0
0
0
0
0
1
0
X
X
Interface4
200C – 200F
1
0
0
0
0
0
0
0
0
0
1
1
X
X
(c) The address ranges are shown in the table above.
5.7
Referring to section 5.4.2: The match logic M for a word i: M i = ( x1 + K 1' )( x 2 + K 2' )( x 3 + K 3' ).....( x n + K n' )
→ M i = [( x1 + K 1' )( x 2 + K 2' )( x3 + K 3' ).....( x n + K n' ) ] = ( x1 + K 1' ) + ( x 2 + K 2' ) + ( x3 + K 3' ) + .....( x n + K n' ) = x1 K 1 + x 2 K 2 + x3 K 3 + ........ x n K n
We have:
x j = A j Fij + A' j F 'ij → x j = A j F 'ij + A' j Fij = A j ⊕ Fij We can say that: n
M i = ∑ ( A j ⊕ Fij ) K j j =1 ' M i is the sum of exclusive-OR
functions. The logic diagram can be easily drawn referring to Fig.5-9.
5.9
In the match logic described in Fig.5-9, when all key bits are zeros
Mi =1
To give no-match result when all key bits are zeros, we can add the following logic: n
M i (new) = M i ⋅ ∑ K i i =1
5.13 Number of lines per set = 4 Line size = 2 word (16-bit word) Total cache capacity = 4K word (32-bit word) = 4 * 2 = 8K word (16-bit word).K Number of lines in the cache
=cache capacity / Line size = 8K / 2 = 4K Lines Total number of sets in the cache = Number of lines in the cache / Number of lines per set = 4K / 4 =
210 sets.
As the processor has a 24-bit address: The cache address will be mapped as f o l l o w s : 1-bit for selecting the word within a line. 10-bits for the Set addressing. The remaining 13-bits will be reserved as tag bits The arrangement will be as follows: 13-bit Tag
10-bit Set
1-bit word
SHEET(5)
1 A computer uses RAM chips of 1024 x 1 capacity. a. How many chips are needed, and how should their address lines be connected to provide a memory capacity of 1024 bytes? b. How many chips are needed to provide a memory capacity of 16K bytes? Explain in words how the chips are to be connected to the address bus. 2
A ROM chip of 1024 x 8 bits has four select inputs and operates from a 5-volt power supply. How many pins are needed for the IC package? Draw a block diagram and label all input and output terminals in the ROM.
3
Describe in words and by means of a block diagram how multiple matched words can be read out from an associative memory.
4
Consider a 32-bit microprocessor that has an on-chip 16 Kbytes four-way set-associative cache. Assume that the cache has a line size of four 32-bit words. Draw a block diagram of this cache showing its organization and how different address fields are used to determine a cache hit/miss. Where in the cache is the word from memory location ADCDE8F8 mapped?
5
A set associative cache has a block size of four 16-bit words and a set size of 2. The cache can accommodate a total of 4096 words. The main memory size that is cacheable is 64K x 32 bits. Design the cache structure and show how the processor's addresses are interpreted.
