RPG 7 Launcher

RPGRPG-7 7 Laun Launch cher  er 

This model is a request from Paper Replika new Facebook group, Paper Replika Friends !n that group "ou can discuss about e#er" model made b" Paper Replika and also "ou can make suggestion or request of model that "ou like and want to be made as paper model pattern $#er" request will st ill filter b" me, and onl" appro#ed requests will be made This RPG-7 paper model template contains %& pages of patterns The scale is '(', so ) also made its inner  construction The warhead can be detach but with simplified model ) recommend to use *&& gsm paper and thicker  for its inner constructions This +o#iet portable unguided rocket missile is #er" popular hea#" weapon among armed forces in man" countries +ome countries copied its design or reproduce under license

 ssembl" construction stick for the proectile warhead .77 and 7/0 using part 71 inside them 2ou can add additional rolls of paper inside it to add strength if "ou want to ttach the stick with back part of the warhead .*/,*7 and %&0

3omplete the warhead b" adding part *,% and ** on the front segment and part 4 and fins .part 50

 ssembl" the middle part of the launcher .56,54,51,6% and 5/0 using part 1' inside part 56 and 54 ll parts seams are at the bottom e8cept for part 6%, its seam is on top 2ou ha#e to be careful not to make mistake on those seam alignments

 ssembl" the wooden heat co#er part .',6 and 10 and then insert part 76 on the inside Push part 76 until it touches the inner side of part 1, add glue to make them stick together lign both seams on top and bottom

3omplete the wooden heat protection co#er with part 7 and '6

 ssembl" the constructions stick part .1*,16,14 and 1&0 with part 71 inside them 2ou can add more roll of paper or  thicker paper inside it to add strength

3ombine front and middle part of the launcher with pre#iousl" assembled construction stick 9atch the red line on part 14

 ssembl" the rocket e8haust cone part .6&,66,64,6,4',4* and 460 :alle" fold on part 4*

3ombine the e8haust cone with the rest of the launcher base

 dd details according to the image abo#e

Place part %6 on the e8posed part 5%;5* to co#er the white paper sides

Glue the trigger to a sheet of paper .part '&0 that were glued first inside part 7*, that wa" the trigger can swing back when "ou pull it with part '& as a hinge

 lign the seam correctl" at the bottom on part 1%

2ou must agree on
P