ROUTE V7 CHAPTER 1 EXAM JUNE 29, 2016 | ADMIN | LEAVE A COMMENT
Question 1 Which two major areas can be used when discussing the high-level overview of a typical enterprise network? Choose two. Campus backbone Building distribution Building access
Enterprise campus
Enterprise edge
Question
2 Which
of the following is used when choosing a dynamic routing protocol? Choose two. Cost of equipment Knowledge level of a specific routing protocol Scalability Type of links supported
Question 4 Which two factors can influence convergence time for a routing protocol? Choose two. Fine tuning routing protocol timers Number of end devices with IP addresses. http://ccnpv7.com/2016/06/29/route-v7-chapter-1-exam/
Question 5 Scalability of a network includes which two factors? Choose two. Number of adjacent neighbors Number of routers Distance between routers Ability to do auto summarization
Question
6 Which
of the following traffic types is not supported by IPv6? Unicast Multicast Anycast Broadcast
Question 7 What is the IPv6 multicast address used by EIGRP? FF02::5 FF02::6 FF02::9
FF02::A Question 8 Which type of IPv6 address is used by routing protocols for communications only on the link? Unique local Site local
Link-local Multicast
Question 9 Which type of ICMPv6 message is sent by a device to request information about the network such as the prefix, prefix length and default gateway? Neighbor Advertisement Neighbor Solicitation Router Advertisement
Question 10 Which type of ICMPv6 message is sent by a device to inform another device of its IPv6 address and associated Ethernet address? Correct! Neighbor Advertisement Neighbor Solicitation Router Advertisement Router Solicitation
Question 11 Which type of network allows access to multiple devices on the same network but does not provide broadcast capabilities? Point-to-point Broadcast NBMA Multi-access
Question 12 Which type of subinterface provides connections similar to physical point-to-point links and has no neighbor discovery issues? Correct! Point-to-point Point-to-multipoint Multipoint All of the above
Question 13 Which tunneling protocol was developed by Cisco to encapsulate a Layer 3 protocol inside a point-to-point, tunnel-over-IP network? Correct! GRE DMVPN IPsec MPLS
Question 14 A Layer 3 MPLS VPN over GRE is an example of what type of VPN? DMVPN Multi-VPN Combination VPN Hybrid VPN http://ccnpv7.com/2016/06/29/route-v7-chapter-1-exam/
Question 15 What protocol is used by routers implementing DMVPN to determine the next-hop IP address in tunneling networks? Dynamic GRE
NHRP mGRE MPLS
Question 16 What framework of open standards that provides confidentiality, data integrity, authentication and anti-replay protection? Correct! IPsec VPN PAP PSK
Question 17 R1 has an adjacent RIPng neighbor R2. R1 has a LAN with no neighbors, 2001:DB8:ACAD:1::/64. R1 advertises this prefix to adjacent RIPng neighbor, R2. What metric does R2 display for 2001:DB8:ACAD:1::/64? 1 hop
2 hops 3 hops 4 hops
Question 18 How is an interface enabled for RIPng? You nswered Using the network prefix/prefix-length router mode command Using the ipv6 rip name enable interface command Interfaces are automatically enabled for RIPng when the RIPng process is started Using the router ripng name interface command
Question 19 Router R1 has multiple routes in its routing table including RIPng routes, directly connected networks and a static default route. R2 http://ccnpv7.com/2016/06/29/route-v7-chapter-1-exam/
receives a default route from R1 but no other routes. This is because R1 uses which option at the end of ipv6 rip name default-information interface command? static originate default-onlyCorrect! only CCNP V7 ANSWERS
