First Install XP mode from windows 7 support website http://windows.microsoft.com/en-us/windows7/install-and-use-windo http://windows.microsoft.com/en-us/wind ows7/install-and-use-windows-xp-mode-in-windows-7 ws-xp-mode-in-windows-7 Then Install windows virtual PC, you can find the installation procedure in the above link. After that Run Windows XP Mode. 1.
In Windows 7, click the Start b utton Start bu click Windows XP Mode. Mode.
, click All Programs, Programs, click Windows Virtual PC, PC, and then
2.
In Windows XP Mode, insert the program's installation disc into your computer's CD/DVD drive; or browse to the program's installation file, open the file, and follow the instructions to install the program.
When PL7 is installed you can see the installed software in the list as shown below:
To Configur e Unitelway Driver and TSXPX3030 cable in XP Mode fol low the foll owing procedure. 1. Connect the TSXPX3030 cable to the laptop USB port 2. At the top of the windows desktop you will see a blue bar, click USB and a drop down box will appear. Click attach. 3. Click start, right click my computer, click properties and then device manager, click com ports and the cable should be visible there on com 1. 4. Double click the cable on com port 1 and a new window will open, click port settings, and change the settings to these: Bits per second = 9600 Data bits = 8 Parity = odd Stop bits = 1 Flow control = none 5. Click advanced and change the settings to these (Optional): Use flow buffers = unticked Com port number = com 1 (any com port available). 6. The cable is now installed correctly and using the right connection settings. 7. Now click start, all programs, Schneider electric, communication drivers and then drivers’ manager. 8. A new window will open, click unitelway driver and then configuration, a new window will open, click edit and another window will open. 9. Within this window you will see 3 tabs unitelway, line parameters and advanced, change the settings in these tabs to these: Com port = 1 (com port on which cable is connected) unitelway slave address = base 1 numbers 3 Baud rate = 9600 Self-adaption = unticked Data bits = 8 Parity = odd Stop bits = 1 RTC/TX delay = unticked Link type = unitelway num plc = unticked Link timeout = - 1 RX/TX delay = - 1 Force virtual com port = ticked 10. Click ok and then apply and the unitelway driver will reset itself 11. Plug the cable into the terminal and click connect to PLC within PL7 PRO and it should connect.
