Open and Double Flame Boxes

Model and Diagrams © Dennis Walker 

Open out

Repeat last two steps on right side and open out entirely Page 1 of 4

Model and Diagrams © Dennis Walker 

Starting point for  Double Flame

Make 3D

 A

Tuck this under the edge underneath.

B During assembly, B goes OVER A (i.e. A goes inside B). Note that the far edge of  B can be used to hold down the folds under the flame/petal

 A

B

The white part of the A flame/petal goes under  the coloured part of the B flame/petal.

Variation of Open Flame. Uses same body. Model and Diagrams © Dennis Walker 

Fold Open Flame Lid up to and including the diagram marked

Fold and unfold. Top Layer only Make 3D Separate layers (pull paper from behind)

Lift Top Layer to form first flame/ petal using existing creases.  Allow it to curve. Squash the flap. The valley fold indicated lies along the centre line underneath.

Fold flap under 

Soft petal fold

X5  Assembly similar to Open Flame

Page 3 of 4

Model and Diagrams © Dennis Walker  (Note: Unconfirmed suspicion that this may be an independent discovery of a base by Tomoko Fuse)

 Add the pinch marks shown

One unit complete

Page 4 of 4