This presentation will showcase free sample PMI-ACP® sample questions that will help and guide you in studying for your PMI-ACP® exam Find more free sample questions when you visit http://bit.ly...Full description
A reviewer for Chemical Engineering Board Examinations....Full description
1. Describe what would happen if the surface of a ballast tank is coated without removing soluble salts once in service. 2. Name four four types of of corrosion and briefly briefly describe describe them. 3. Name the two types of intumescent coatings and describe what areas they would used in. 4. Briefly describe describe in general terms ISO 4628 4628 parts parts 1-6 5. Name the 5 pre surface condition in ISO8501 – 4 and the benefits of high pressure water jetting. 6. Describe what information informatio n should be included in an inspection test plan
Multiple Choice Questions Questions If you suspected oil or moisture in the compressed air during blast cleaning which test would you perform?: a) Bresle b) Blotter test c) Nozzle orifice test d) Hypodermic needle gauge test What is the recommended process if amine bloom has occurred on a coating if additional coats are still to be applied? : a) Fully re blast back to bare steel b) Flash blast the coating c) Fresh water wash d) Solvent clean An impressed current current cathodic protection protection system in in an aqueous environment environment requires requires an anode that: a) Slowly dissolves in Seawater b) Is Inert c) Generates a voltage when in contact with water d) Produces metallic ions
A flow cup is used to measure the viscosity viscosity of paints that: a) Have a low rate of shear b) Have a high rate of shear c) Have a low specific gravity d) Have a high specific gravity
