Model no. PIC114 :The main objective of the project is to develop a GSM based energy meter reading system and load control through SMS. Watch the out...
This system is designed for reading electrical energy consumed in units and in kyats to display on an LCD screen to the user. This system becomes necessary for the consumer to know as to how much electricity is consumed to control electricity bill wi
The IOT based energy meter is based on Arduino. This system eliminates the human involvement in electricity maintenance. The theft of electricity increases the costs paid by customers. Hence this system is used for the detection of theft. The energy
absFull description
It's a Microcontroller Based DIY Electronics Project. Named Wireless RF Module Using PIC Microcontroller. The RF module is a small electronic circuit used to transmit, receive, or transceive…Descripción completa
Model No.PIC115: The aim of this project is to remind people who forget to take their medicines on time. Watch the output video and get more knowledge on this project by visiting the webpage: http...
A fire alarm system is used our properties safe form fire. It can be designed in many ways in different components. Many expensive building must have their fire alarm systems. In market almost systems are indoor systems. The indoor systems can be kno
ZxcvbnbvcxDescripción completa
street lights are switched on for the whole night and during the day they are switched off. But during the night time there is no need of street lights if there is no traffic. Saving of this…Full description
street lights are switched on for the whole night and during the day they are switched off. But during the night time there is no need of street lights if there is no traffic. Saving of this…Full description
ZxcvbnbvcxFull description
hiFull description
Description of Energy Meter.Full description
This paper investigates based on coin acceptor vending machine using microcontroller system. Technology has become a part of the different aspects of peoples' lives as it makes most of their work faster and easier. One of the fast paced technologies
This paper investigates based on Raspberry PI based home appliances control system using microcontroller system. The paper proposes to control home appliances remotely using smart phone. In this paper, Raspberry Pi is used as a sever for connecting t
Microcontroller
GSM BASED ENERGY METER READING WITH LOAD CONTROL USING PIC MICROCONTROLLER
ABSTRACT The main objective of the project is to develop a GSM based energy meter reading system and load control through SMS. Electricity department sends employees to take meter reading every month, which is an expensive and time consuming job. The proposed project provides a convenient and efficient e fficient method to avoid this problem. The electricity department and the user can get the readings of the energy meter of consumers via SMS. The loads can also be controlled by the user of o f this system system via SMS using this project.
A microcontroller input is effectively interfaced to a digital energy meter that takes the reading from the energy meter and displays the same on an LCD. The reading of the energy meter is also sent to the control room by an SMS via SIM loaded GSM modem. This GSM modem can also receive commands from the cell phone to control the owner’s electrical loads. It uses a standard digital energy meter that delivers output pulses to the microcontroller to perform counting for necessary action. On receiving command it can switch ON/OFF the loads. Further this project can be interfaced with a non volatile memory IC like EEPROM along with a keypad so that the user the change the mobile number as per the requirement.
.
BLOCK DIAGRAM:
HARDWARE REQUIREMENTS:
SOFTWARE REQUIREMENTS:
PIC16F8 series Microcontroller, Max232, GSM modem, LCD, LED, Crystal, Relay driver IC, Resistors, Capacitors, Diodes, Transformer, Voltage Regulator, Opto Isolator, Digital Energy Meter, Lamp.
MPLAB & CCS C compiler Language: Embedded Embedded C or Assembly Assembly
