Generator Checklist

APPENDIX 1 PREVENTIVE MAINTENANCE CHECKLIST EMERGENCY STANDBY GENERATORS/SWITCHES/ GENERATORS/SWITCHES/CONTROLS CONTROLS

Agency Representative: ________________________ (Print Name)

_________________________________ (Signature)

Location : ___________________________ Time: _____________

Date: _____________________

Hour Meter: _________________________ Unit Mfg. ______________________ ______________________

Model: ______________ ______________

S/N:_ _____________________

Engine Mfg: ______________________

Model: ______________ ______________

S/N:____________________ S/N:____________________

Gen. Mfg. ______________________ ______________________

Model:_______________ Model:_______________

S/N:____________________ S/N:____________________

SECTION A – COOLING SYSTEM

1. 2. 3. 4.

SAT. UNSAT. (check one)

Engine coolant level Radiator core/heat exchanger Coolant lines/connections/hoses & connections Water jacket heater(s)

Note: Contractor is responsible for replenishing of necessary fluids where there is an unsatisfactory rating. SECTION B – D.C. ELECTRICAL SYSTEM

1. 2. 3. 4. 5. 6.

SAT. UNSAT. (check one)

Battery(s) electrolyte level/specific gravity Battery compartment/heater cooperation Battery connections/cables/casing connections/cables/casing Shutdown mechanisms Electrical starter/alternator generator Electrical system, accessories & components

Note: Contractor is responsible for indicator lights, indicator lamps, gauges, switches, relays, contactors, solenoids, coils, voltage regulators, sensors, fuses, pressure sensing switches, transformers, power supplies, battery cables and connections. SECTION C – A.C. ELECTRICAL ELECTRICAL SYSTEM

1. 2. 3. 4. 5.

SAT. (check one)

UNSAT.

A.C. wiring Battery charger Control panel/switchgear A.C. generator voltage regulator Electrical system accessories & components

Note: Contractor is responsible for the same components listed under Section B-D.C. Electrical System.

T1399 7/12/07

1

APPENDIX 1 PREVENTIVE MAINTENANCE CHECKLIST EMERGENCY STANDBY GENERATORS/SWITCHES/CONTROLS SECTION D – AIR INDUCTION & EXHAUST SYSTEM

1. 2. 3. 4.

SAT. UNSAT. (check one)

Air cleaner units/oil bath and dry type Air induction piping and connections Turbocharger/blower Exhaust manifold/piping/connections

Note: Contractor is responsible for replacing air cleaners, all types. SECTION E – POWER UNIT

SAT. UNSAT. (check one)

1. Generator structure 2. Clutch assembly (power take off) 3. Coupling(s) SECTION F – LUBRICATION SYSTEM

1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13.

SAT. UNSAT. (check one)

Engine oil level Engine oil change Engine oil filter change Engine oil sample for analysis Crankcase pressure Crankcase breather Oil leaks (hoses, connectors) Engine governor oil level/linkage (UG8) Fan drive bearings Generator bearings Engine starter oiler (air type only) Gauges and safety mechanism Accessory drives

Note: Contractor is responsible for replacing any and all engine oil, lubricant, filters and/or belts. SECTION G – FUEL SYSTEM

1. 2. 3. 4. 5.

SAT. UNSAT. (check one)

Fuel tank/day tank  Fuel filters-primary/secondary Fuel system components/hoses/piping Gauges and Safety mechanism Condensation/water in fuel

Note: Contractor is responsible for replacing all fuel filters (primary and secondary) REMARKS:

Technician: __________________________________________________ T1399 7/12/07

2