Fuel Pressure Piping: Removing, Fitting and Regrinding of Sealing Faces
2.
Fitting Fitting procedure is analogous to the removal but in reverse sequence. CHECK
Before fitting fuel pressure pipe 3 check whether its claws 5 are screwed on properly, i.e. the fuel pressure pipe must protrude by ’x’ = 11 mm compared to the claw as shown in Fig. ’C’. Measurement ’x’ can be adjusted by turning the claw using an open end spanner. ⇒
Fit fuel pressure pipe and fasten it as stress-free as possible.
⇒
Apply Never-Seez NSBT-8 to threads of screws 6 and tighten them crosswise with a torque of 40 Nm.
Connection piece 9 is smeared with Never-Seez NSBT-8 and thightened with a torque of 700 Nm).
Retighten the holder and pipe clips according to 0380 −1.