SAP Web Dynpro ABAP Interview Questions With AnswersFull description
SAp Web Dynpro best practice
Full description
Web applications are programs those are created in a language that supports browser like JavaScript, CSS and HTML and run on web browser.
this assigngment is related to web application development
laravel webFull description
WDAFull description
This is a Native American scholarship offered by AT&T employees. To learn more about this organization, visit http://www.icae4nativeamericans.org/index.htm.Descripción completa
Application Program Interface API widely used for the programmers. It helps programmers to focus on their programming rather than the other features. API provides the facility to programmer for use the Predefined Code. Among them one type of API pro
A Web crawler or spider crawls through the Web looking for pages to index, and when it locates a new page it passes the page on to an indexer. The indexer identifies links, keywords, and o…Full description
Consuming a Web Service in ABAPDescripción completa
Piano Michel CamiloDescripción completa
Piano Michel CamiloFull description
Consuming a Web Service in ABAPDescription complète
Debugging ABAP Code from within Web Dynpro Application Let us assume you have a Web Dynpro application that calls function modules using Adaptive RFC, and you want to debug the corresponding ABAP code from within the Developer Studio. You can do this quite simply, provided that the SAP GUI is installed on your local machine and the ABAP system is connected to via a dedicated server (no load balancing). You then only have to activate the relevant setting for external debugging in the ABAP Workbench and set the breakpoint in the ABAP code before starting the Web Dynpro application on the J2EE Engine. Prerequisites • •
You have debugging authorization in the ABAP Workbench in the relevant system. Since debugging in the ABAP system via load balancing is not supported, you must reconfigure your JCO destinations so that the calls take place on a dedicated ABAP application server. For Web Dynpro, this is done in the Web Dynpro Content Administrator. Admini strator. In the destination maintenance, specify Single Server Connection as Connection as the Destination Type .
Step-by-Step Procedure 1. Use the SAP GUI to log on to to the system or server to which the RFC call is to take place.
You should log on with the same user with which the call will take place. Due to the large amount of parallel calls, using a collective user is not recommended. You should try to execute the application with a dedicated user throughout the duration of the debugging session. 2. Activate external debugging in the ABAP Workbench. a. To do this, this, call the ABAP Workbench using one of the transactions SE37, SE38, or SE80. b. Choose Utilities Æ Settings and then the ABAP Editor tab followed by Debugging . c.
Enter the user for which the debugging session is to to take place. Select the Active checkbox and deactivate IP-Matching .
d. Save your settings. 3. Set an HTTP (external) (external) breakpoint in the ABAP code. a. Display the source code of the the relevant function module. b. Position the cursor at the place in the the source code where execution is to to be stopped. stopped. c. Choose the external breakpoint icon The relevant line is highlighted.
from the toolbar.
Note that the validity period for the external breakpoint is limited to 2 hours. If you require more time to debug, you must set the breakpoint again. 4. Start the J2EE Engine and – if you have not already done so – deploy your application. 5. Start your test application on the J2EE Engine. The following example of a Web Dynpro application is used to display flight data from the R/3 system in a table.
The J2EE Engine establishes a connection to the SAP GUI and starts the ABAP Debugger in a GUI session. The Debugger is stopped at the line in the ABAP code at which the breakpoint is set.