The client accepts the offer from the DHCP server for the 10.1.10.21 IP address.
Question 3
1 / 1 pts
Which statement describes what occurs when a DHCP request is forwarded through a router that has been configured with the ip helper-address command?
Correct!
The router replaces the broadcast destination IP address of the DHCP request with the unicast IP address that is specified with the ip helper-address command.
Refer to the exhibit and the partial configuration taken on routers RTA and RTB. All users can ping their gateways, but users on VLAN 5 and VLAN 10 cannot communicate with the users on VLAN 20. What should be done to solve the problem?
Correct!
A dynamic routing protocol or static routes should be configured on the routers.
Refer to the exhibit. What additional configuration is required for host A to receive IP configuration from the DHCP server?
Correct!
The ip helper-address 10.1.2.10 command is required on interface Fa0/0.
Question 8
1 / 1 pts
A client computer is set up for DHCP and needs an IP configuration. During the DHCP client configuration process, which response will enable the client to begin using the assigned address immediately?
Refer to the exhibit. The router has been properly configured for the t runking interface. Which statement is true about the routing table on the router?
Correct!
It should contain routes to the 10.10.10.0/24 and the 10.10.11.0/24 networks.
Question 11
1 / 1 pts
Which two statements are true about routed ports on a multilayer switch? (Choose two.)
A client sends a request for an IP address to a DHCP server. Which DHCP message to the client will provide the configuration parameters that include an IP address, a domain name, and a lease for the IP address?
Correct!
DHCPOFFER
Question 17
1 / 1 pts
Refer to the exhibit. Host A is unable to obtain an IP address from the DHCP server. Which procedure would solve this problem?
Correct!
Use the command ip helper-address 10.1.2.10 on interface Fa0/0 of router RTA.
Refer to the exhibit and the partial configuration taken on router RTA. Users on VLAN 5 cannot communicate with the users on VLAN 10. What should be done to fix the problem?
Correct!
The subinterfaces of the router should be configured with 802.1Q encapsulation.
Question 19
1 / 1 pts
How is the Layer 2 f unctionality restored to a port configured for Layer 3 operation?