REQUIREMENTS • Scissors or sharp hobby knife • White glue, glue stick, or tape • Straight-edge if using hobby knife
• Cutting board if using hobby knife • Spacious work surface • Free time
INSTRUCTIONS
GUIDELINES
1. Print the desired pages. The color minis work best on color printers and black and white printers which are capable of 600dpi minimum (1200dpi recommended). Black and white minis are recommended for black and white injets and all laser printers.
1. PAPER For best results, use 65 to 67lb cover stock. If your printer supports heavier paper, go with 90lb. You will most likely need to use your printer’s manual feed in order to accommodate 65lb and heavier stock.
2. Cut out the desired miniatures along the solid lines.
2. PRINTING You may print as many copies as required, provided it is for personal use. Duplication of the original PDF file is prohibited except for the purpose of backing up your data.
3. Fold the miniatures along the dashed lines. 4. Glue or tape tabs together. not to use too as this may paper.
the bottom Be careful much glue, warp the
3. COPYING You may also photocopy (or color laser copy) minis which you have printed for personal use only. 4 ASSISTANCE If you run into problems or would like to provide feedback, please contact INFO @ PIGAMES . NET or visit the forums on the pigames.net web site.