Design of corbels as per IS and BS codesFull description
Design Procedure in Accordance to NSCP 2010Full description
Full description
ACI PTFull description
Design of shear wall as per ACi method
For ACI 318-08 Herein describes in detail the various aspects of the post-tensioned concrete design procedure with the American code ACI 318-08 [ACI 2008].Full description
beton
aci manual
Design of corbel
Frame Design
structureFull description
Full description
Descripción completa
aci, aci, aci, aciDescripción completa
Full description
Full description
Design of Corbel (ACI 318-08, Section 11.8)
Design Shear (Factored) V Design Tension (Factored)(Min = 20% of V) N Grade of Concrete f'c Grade of Steel fy Width of Corbel b Total Depth of Corbel h Eccentricity of Load V av Cover to Main Reinforcement co Assume Dia of Main Reinforcement db Effective Depth d = h - co - db/2 Strength Reduction Factor φ (Section 11.8.3.1) Check av/d < 1 Design for Flexure + Tension (Section 11.8.3) Design Moment Mu = V×av + N×(h-d) Assume area of Steel for Flexure Af Mu ≤ φMn Now, Design Moment ≤ Design Capacity a = Af×fy/ (0.85×f'c×b) Depth of Equiv. Rect. Stress Block Fexural Capacity of Section φMn = φ×Af×fy×(d-a/2) Mu ≤ φMn Check An = N/(φ×fy) Area of Steel Required for Direct Tension Total Area of Steel Required As = Af + An Design for Shear (Section 11.8.3.2 and 11.6) Coefficient of Friction µ Avf = V/(φ×µ×fy) Area of Shear Friction Rein Reqd Check
= = = = = = = = = = =
163 40.75 32 420 1000 300 150 70 16 222 0.75 OK
kN kN N/mm² N/mm² mm mm mm mm mm mm
= =
27.6 550
kNm mm²
= =
8.5 37.7 OK 129 679
mm kNm
= =
= =
1.4 370 OK
mm² mm²
mm²
Design Reinforcement (Section 11.8.3.5, 11.8.4, 11.8.5) Area of Main Reinforcement (Asc) shall be larger of 1) or 2) 1) Asc = Af + An 2)Asc = 2/3×Avf + An Therefore, Area of Main Reinforcement Reqd Asc Minimum Area of Main Reinf Asc = 0.04×f'c×b×d/fy Check Area of Strirrups Parallel to Main Reinforcement Ah = 0.5×(Asc-An)
