CCNP TSHOOT Chapter 1 Assignemnt

Question 1 What is a potential drawback to selecting the bottom-up general troubleshooting procedure? requires checking every protocol requires checking every application requires checking every device and interface requires checking the route table at each router requires checking the path from source to destination Question 2 After a network change that occurred during a scheduled maintenance window, users were complaining about not being able to access a local file server. Upon investigation, the administrator determined that the problem was with the recently entered routing configurations. Because of company policy, the administrator is not allowed to correct the routing configuration outside of a scheduled maintenance window. Instead, the administrator moved the file server to an accessible subnet. Which statement describes what the administrator did? The administrator determined a solution to the problem. The administrator determined a workaround for the problem. The administrator applied the "swap components" troubleshooting approach. The administrator applied the "perform comparison" troubleshooting approach. Question 3 What are two limitations of an ad hoc troubleshooting approach? (Choose two.) inefficient use of time and resources only applicable to physical layer problems difficult to transfer the job to someone else can only be used after a structured approach has failed requires more technical knowledge than a structured approach

Question 4 The help desk receives several calls on Monday morning stating that users cannot connect to a local print server that was working on Friday. Which statement about the problem would be correct? The inability to connect to the print server is a symptom of a problem. The inability to connect to the print server is the problem. The connectivity problem occurred Monday morning. The inability to connect to the print server caused the problem.

Question 5 Which condition is a symptom of a connectivity issue on a router that provides access to the Internet? A static route is misconfigured. An interface status is down. An incorrect network statement exists. A cable is unplugged.

Question 6 What is a symptom of an incorrectly applied network command when issued under the routing process? a down status on an interface a timeout message when attempting to ping a device on another network a routing protocol that is not running a user who is unable to connect to machines that are located on the same subnet

Question 7 Users at a remote site have reported that it is no longer possible to access the Internet. A network administrator issued the show interface S0/0/0 command to check the status of the interface. Which troubleshooting approach would fit this situation? top-down bottom-up follow-the-path divide-and-conquer

Question 8 A network engineer compares the routing table of a working router with that of a router that is experiencing connectivity issues. Which troubleshooting approach best describes this scenario? bottom-up approach divide-and-conquer approach follow-the-path approach swap-components approach perform-comparison approach top-down approach

Question 9 A network engineer initially uses the ping command to help troubleshoot a connection problem. Which troubleshooting approach best describes this scenario? bottom-up approach divide-and-conquer approach follow-the-path approach move-the-problem approach spot-the-difference approach top-down approach Question 10 What is common between Layer 3 switches and routers? the supported features the packet forwarding processes the Layer 2 protocols on the interfaces the commands for troubleshooting the control plane Question 11 What is an important element of troubleshooting, regardless of the method used? using a single troubleshooting process executing the steps in the same order every time following a structured and systematic process spending a significant amount of time analyzing the information Question 12 Network users have complained that it is no longer possible to access an important web-based application. Using the ping command, an administrator verifies that there is connectivity between one of the workstations and the server. The administrator has also determined that BGP connectivity has remained established. At which layer of the OSI model is the problem most likely to be found? Layer 1 Layer 2 Layer 3 Layer 4 Layer 5 Layer 6 Layer 7