Briggs and Stratton Intek V Twin repair manualFull description
Briggs and Stratton Intek V Twin repair manualDescripción completa
Description : PPT presentation of different types of valves with their uses & limitation
ValvesFull description
Deskripsi lengkap
Adjusting Entries
technical sheetDescription complète
Valves
basics
For Accounting people
asdsaFull description
Descripción completa
Slideshow in pdfFull description
Full description
Check Valves
Valves
cv
Full description
Adjusting Overhead Valves 1.
Release the brake spring. Then, turn the flywheel to close both valves.
2. Insert a narrow screwdriver into the spark plug hole and touch the piston. Turn the flywheel clockwise past top dead center until the piston has moved down 1/4". Use the screwdriver to gauge the piston's range of motion (image F). PLEASE NOTE: This procedure must be performed for each cylinder on V-Twin engines.
3. Check the valve clearance by placing a feeler gauge between the valve head and the rocker arm (image G). Clearances differ for the two valves and typically range from .002 - .004" to .005 - .007". Valve clearance specifications for your engine series are available by viewing our Engine Specifications Chart (pdf).
4. Adjust the clearances as required by turning the rocker screw. Once adjustments are completed, tighten the rocker nut. 5. Install the valve cover, using new gaskets, as required, and make sure the cover is secure. NOTE: Please read and abide by any applicable Safety Information (PDF) before performing any engine work. This information is not meant to take the place of work performed by a Briggs & Stratton Authorized Dealer . Terms and Conditions apply to all of our information provided on this website. Always be sure to read and understand your engine Operator's Manual.
