es un manual que describe el uso de un driver de motorFull description
Full description
Manual de usuario de bomba de infusion
Descrição completa
filament winding
user manual for users to use this usable things
user manual diesel engines
Bj Manual Elevators User ManualDescripción completa
JamsostekFull description
manualde servico stat fax 4700Descripción completa
Descripción completa
Descripción: Amberfin 11 User Manual
UserManualDescripción completa
;lokhjhjlkjpolkpjlk
BarracudaFull description
Full description
Full description
11.2.4
"VLAN based in-band" management
This procedure allow the access of "ALFOplus" unit by "Ge main port" more safely, because the IP domain is independent of payload traffic through dedicated "VLAN tag" (configurable). This mode can be used when the user is owner of "VLAN tag" and the equipment is interposed in a level 2 network traffic (switching). In that case the management routing is obtain to filtering of "VLAN tag".
Ge Main port
Ge Aux port
CPU Vlan map filtering Fig.40 - VLAN based in-band management To reduce the visibility of the controller to line side ( ), radio side ( ) and extent supervision network () you can enable or disable the paths indicated in filtering "VLAN tag". The path () can be enabled only if both line ports, are enabled to "In-band" management. In case of protection configuration through LAG or ELP, the path () cannot be enabled.
11.2.5
"VLAN based In-band" drop node
This particular way allows to introduce the supervision traffic "VLAN based In-band" (mandatory with "VLAN tag") using "Ge Aux port" obligatorily without "VLAN tag". The line ports are linked together using the filtering "VLAN tag" (set as tagged the default port "Ge aux port").
Ge Main port Ge Aux port
MGT
CPU Vlan map filtering
Port based vlan
Fig.41 - VLAN based In-band drop node This mode allows the supervision of outdoor units placed in the same site, but excludes the possibility of simultaneous monitoring "Out-of-band" in the network. The insertion direction (on the line and radio side) can be selectively enabling or disabling the paths corresponding ( and ). This mode is not available in the case of interfaces in a secure configuration.