This document helps in creating IDOC's.Description complète
Description complète
Panduan Software MIKEFull description
Step-by-step photographic guide with inspirational projects to make succesfull woodworking.Descripción completa
CMG step by step guideDeskripsi lengkap
This document helps in creating IDOC's.
Step by step learningDescription complète
C# Step by Step
Step by step learning
Procast Step By Step GuideFull description
Procast Step By Step Guide
cozinha
7229 VGS Offline Replace Step by Step instructions using FVDI: Well, here we go: Your machine must be offline enabled and flash data mounted!!!! Read out/save SCN coding and EHS# from vehicle using OBDII c onnector Printout your control unit version page Set up virgin vgs to fvdi on bench using the obd connector according to the following:
1. 12v to pin 16 on OBD and pin 4 on ETC 2. CAN HIGH pin 6 on OBD->>>pin 1 on ETC 3. CAN LOW pin 14 on OBD--->>>pin 2 on ETC 4. Signal GROUND pin 5 on OBD---->>>>pin 5 on ETC 5. Chassis GROUND pin 4 on OBD----->>>ground on power-supply
Transfer SCN coding and EHS# you saved into the virgin VGS module to car(I let it hang from connector)
Replace VGS
Plug in old control
Go into development data in ETC->control ETC->control unit
adaptations->Read coding and/or transfer download data to new control unit
follow the next next
steps(it will say that not all coding can be exchanged....(its ok) after you plug back in and it transfers coding it will say not all data could be exchanged, do you want to do manual settings now? say later/NO
On main ETC page
control unit version, make sure your EHS# matches the original
from the control unit version page you printed out, just the EHS# must match, If it does not match goto
development data-
control unit adaptations(download)
ZBEHS
enter the original EHS#
from control unit version sheet you printed at the very beginning of job. 1 means it was transferred ;) Well, now in the Main ETC page offline programming
Control unit adaptations
control module programming
hard disk data. (I use a LAN cable with my C4 for this just to make sure
complete programming will be successfully done :P transport/personalize/activate
control unit adaptations
detach
follow prompted steps.
Done! Please note that: this process has been proven and tested on cars with VGS2 and newer only.