Bearing Sprag Snap Low Clutch Ring Press. Plate .140 .133
3 Double sided Frictions & 3 Steels.
This area feeds lube to the Center of Shaft
Return Spring
Low Clutch Piston
Low Clutch Housing
Use an Impact Driver and a med. hammer to remove bolts. DO NOT use an impact gun!
Compounder Shaft
This area feeds lube to Sprag
All 4 solid sealing rings were shrunk & had no drag in LC Housing. Loss of lube will accelerate wear on LC housing. See next page.
Bearing Retainer
62TE Low Clutch Assy. & Sprag Has Groove on rear. .058 Hole
Lube
Lube .099 Hole .051 Hole
Lube
Check Sprag rotation by holding here and rotate race in direction of arrow.
Direct Feed
Smooth side faces up.
Rotates
Lube Groove
Direct Feed
Low Clutch Feed
Lube Feed
62TE Low Clutch Wear Area Loss of lube from shrunk sealing rings on the steel shaft will accelerate wear in this area causing Direct drum rings to leak. With severe wear, the top sealing ring may be found still in the drum here.
