pengetahuan dasar tentang gearboxDeskripsi lengkap
vwDescripción completa
Descripción: AVS Automatic gearbox
AVS Automatic gearbox
Paper about gearboxFull description
Wind turbine gearbox design specsFull description
gEARBOX luftkin
Gearbox lawsuitFull description
Lufkin gear box....
VOITH GearboxDescrição completa
Lufkin gear box....
I-shiftFull description
Technical Manual
VAG automatic gearbox repair manual
ASCO Solenoid valves
ImplemFull description
ManualFull description
B2CG6SK1 - 406D9 AL4 AUTOMATIC GEARBOX REMOVAL - REFITTING HYDRAULIC BLOCK - SOLENOID VALVES 1 - REMOVAL 1 - 1 - HYDRAULIC BLOCK WARNING : this operation requires a great deal of care; take all possible cleanliness precautions . Place the vehicle on a lift . Disconnect the battery . Position a tray to retrieve the oil from the hydraulic block cover (Approximately 1,5 litre(s)) .
Remove : ● ●
the casing bolts (1) the casing (2)
Unclip the connectors of sequence solenoid valves, gently levering them with a screwdriver . Disconnect the 6 sequence solenoid valves . Remove the 7 bolts (3) .
Move aside the hydraulic block . Disconnect the solenoid valves (4) - (5) . Remove the hydraulic block . IMPERATIVE : do not drop the manual valve (6) . 1 - 2 - SOLENOID VALVE(S) IN THE HYDRAULIC BLOCK
(6) Manual valve (MV) . (7) EVS1 sequential solenoid valve . (8) EVS2 sequential solenoid valve . (9) EVS3 sequential solenoid valve . (10) EVS4 sequential solenoid valve . (11) EVS5 sequential solenoid valve . (12) EVS6 sequential solenoid valve . (13) Main pressure modulation solenoid valve EVM . (14) Converter pressure modulating solenoid valve (differential solenoid valve) . NOTE : it is not necessary to remove the hydraulic block in order to remove the sequence solenoid valves . IMPERATIVE : as soon as the solenoid valve (11) is removed, ensure that the hydraulic slide valve is
controlled by the solenoid valve, so that it does not fall ; change the solenoid valve seals each time the solenoid valves are refitted . NOTE : the mounting bolts of the solenoid valves are tightened to 1 dan.m . 2 - REFITTING
IMPERATIVE : check the presence of the seals (15) (new seals) . Offer up the hydraulic block . Reconnect the solenoid valves (4) - (5) .
WARNING : take care that the manual valve (6) is engaged in the lug (A) of the notched section (16) .
Replace the mounting bolts in the hydraulic block (Tightening torque 0.8 da.Nm) Follow the order indicated .
Reconnect the 6 sequence solenoid valves . IMPERATIVE : adjust the internal control, the plate (17) and the notched section (16) ; adjust the multifunction switch . Ensure that the gear selector lever functions correctly in all the positions . Fit : ● ● ●
the housing (2) with a new seal the casing bolts (1) (tightening torque 1 da.Nm) the sleeve of the air filter
Connect the battery . Carry out : ● ●
the topping up of the automatic gearbox oil updating of the oil wear counter value
