311810174-Tutorial-Shot-Plus-5.pdf

Document Reference: www.oricaminingservices.com

Introduction SHOTPlus 5 and SHOTPlus 5 Premier Training Course

Introduction Welcome to SHOTPlus 5 and SHOTPlus 5 Premier training course! • •

The course run for full 3 days During this time you will be presented with the complete functionality of SHOTPlus 5 and SHOTPlus 5 Premier • The course is setup in 2 sections - SHOTPlus 5 functionality (10 modules) - SHOTPlus 5 Premier functionality (7 modules) • Do not be afraid to ask questions! - Remember that others will also benefit from you asking • Enjoy the contents and most importantly have fun! - You will learn a lot more if you enjoy the course

© Copyright Orica Limited Group

Course outline SHOTPlus 5 modules

1. SP5 – General interface 2. SP5 – Getting started 3. SP5 – Inputs and outputs 4. SP5 – Drawing tools 5. SP5 – Basic blast design 6. SP5 – Blasthole charging 7. SP5 – Initiation design with Exel 8. SP5 – Initiation design with Electronic Blasting System (EBS) 9. SP5 – Initiation design with cord 10. SP5 – Timing calculations


Course outline SHOTPlus 5 Premier modules

1. SP5 Premier – Advanced Blast design

- Including Profile and Markout tools 2. SP5 Premier – Advanced Blasthole charging 3. SP5 Premier – Surfaces and volumes 4. SP5 Premier – Surveys 5. Blast Management – Table display 6. SP5 Premier - Reports


Module structure 1. Introduction/Overview of the module •

Main aims listed

•

List of topics

2. Topic contents •

The contents of the module divided into functional or logical topics

3. An example •

A step-by-step example demonstrating the main points and ideas raised in the topic contents section, including audinence participation

4. An exercise (available where contents is appropriate)

-

An exercise to be completed by the course participants to strengthen the ideas in the lesson


Questions


311810174-Tutorial-Shot-Plus-5.pdf

Recommend Documents