Warning: This document, is protected by copyright law and international treaties. No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written permission of TEMENOS HEADQQATERS SA. Unauthorized reproduction on or distribution of this presentatio presentation n or any portion of it, may result in severe civil and criminal penalties, and will be prosecuted to the maximum extent possible under applicable applicable law.” Information in this document is subject to change without notice.
Step 1 - Creating The DL.DEFINE Record In Development Env. ID Holds the ID. ID will begin with the last 8 digits in the field LICENSE.CODE in SPF GB Description Holds a description about the records that are available in the data library unit to be created GB Short Desc Holds the short description if any Operation can be S-save or R-restore. S in this case as we are saving a unit which can be restored at any point in time File Name T24 application or directory Record Name valid ID from above mentioned application or directory (i.e routine name ) Record Desc description of the record to be included
UAT Environment Set up the DL.PARAMETER record
This is done to restore the saved unit from the development environment. Verify the record
On verification, a record in the DL.DEFINE application is created with ID TMNS000-TRG with Operation set to R ID Always SYSTEM Replace Chars and Replace With characters can be replaced when the data library is stored (DL.PARAMETER is verified with S operation) Operation S or R Overwriting Y- If units exist in F.DL.DATA, they will be overwritten N – The units are not overwritten L-Units that have been changed lately are alone overwritten Restore Units Unit names to be restored Save Units if blank, F.DL.DATA is saved Tape Device Name of tape device
