INSPECTION & TESTING REQUIREMENTS SAUDI ARAMCO FORM-175
SCOPE:
REVISION: 05/06/2012 REPLACES: 11/29/2011
CODE NUMBER:
IR014300
PAGE:
1 of 1
TUBES: for Condensers, Tubular Heat-Exchangers, and Similar HeatTransfer Apparatus, Seamless cold-drawn low-carbon steel; 1/8" to 3"outside diameter.
TEST AND INSPECTION PER: ASTM A-179, A-178, A-213, A-210 and Specifications As Noted Below. (1) VISUAL INSPECTION WITNESSING BY INSPECTOR (Note 1) (2) CERTIFICATES / RECORDS TO BE CHECKED BY INSPECTOR (3) CERTIFICATES / DATA TO BE PROVIDED BY VENDOR / SUPPLIER / MANUFACTURER
0010 0010
***
X
0020
0020 0010
X
***
0020
Pre-Fabrication/Production Requirements
Specification Details / Notes:
Material Test Reports
Per applicable ASTM
Inspection and test plan
Verify manufacturer ITP
In process inspection & test requirement
Specification Details / Notes:
X
Chemical Composition
Per applicable ASTM
X
Product Analysis
Positive material Identification(PMI) is required only for ASTM A-213
Per applicable ASTM. Random witness is required only for Hardness test.
0040
X
X
Hydrostatic Test or NDT unless otherwise specified in P.O.
Per applicable ASTM
Final inspection & test requirements
Specification Details / Notes:
0030 0010
*** X
Dimensional Inspection including outside diameter, wall thickness, Per applicable ASTM and PO requirement. Length, Squareness of cut ends, number of fins per inch, out of roundness.
0020
X
Visual Inspection of Completed Tubes
0030
X
Identification Marking , packing and shipment of the Product
Per ASTM and PO requirement
Notes: (1)May only be waived by the responsible Saudi Aramco, ASC, AOC Inspection Offices. (2)See form SA175 - 000003 for instructions on using this form. (3)Random sampling and witness should performed by the company representative