Create a new part Open a new part with model units set to millimeters. Go to: File > New > Part
Select the three planes in the feature tree and make them visible by clicking on the glasses.
Create a 2D sketch Select the Front Plane and create a sketch by clicking on the 2D Sketch icon Draw the sketch as shown in the picture with 5 lines and 2 splines.
Create a fillet on the four corners of the peddle Go to: Insert > Features > Fillet/Round or click at the Fillet icon Select the two edges as shown in the picture. Change the Radius into 60 mm Click OK
Create a fillet on the four corners of the peddle Go to: Insert > Features > Fillet/Round or click at the Fillet icon Select the two edges as shown in the picture. Change the Radius into 17.50 mm Click OK
Create a Fillet Go to: Insert > Features > Fillet/Round or click at the Fillet icon Select the two surfaces as shown in the picture. Change the Radius into 1 mm Click OK
Create a new plane parallel at the Top Plane Go to: Insert > Reference Geometry > Plane Select the Top Plane as shown in the picture. Change the Offset Distance
into 17,5 mm.
Ensure that the offset is directed to above. If not, click “Reverse direction”
Create a fillet on the four corners of the peddle Go to: Insert > Features > Fillet/Round or click at the Fillet icon Select the blue edges and surface as shown in the picture. Change the Radius into 1 mm Click OK
Create a Chamfer Go to: Insert > Features > Chamfer or click at the Chamfer icon Select one green edge of Extrude3 as shown in the picture. Select the “Distance – distance” option. : 16 mm : 9 mm Click OK
Create another Chamfer Go to: Insert > Features > Chamfer or click at the Chamfer icon Select one green edge of Extrude3 as shown in the picture. Select the “Distance – distance” option. : 16 mm : 7,5 mm Click OK
Create a new plane parallel at the Front Plane Go to: Insert > Reference Geometry > Plane Select the pink surface as shown in the picture. Change the Offset Distance
into 20 mm.
Ensure that the offset is directed to above. If not, click “Reverse direction”
Create a Linear Pattern Go to: Insert > Pattern/Mirror > Linear Pattern or click at the Linear Pattern icon Select an edge that lies parallel at the direction of the pattern. This could be the green line as shown in the picture. Change
Create a fillet on the four corners of the peddle Go to: Insert > Features > Fillet/Round or click at the Fillet icon Select the blue surfaces as shown in the picture. Change the Radius into 1 mm Click OK